20 Most Recent
FoodSaver Smart Seal Vacuum Sealer V3825 - Page 11 Questions & Answers
Why won't my cordless vax switch on and run
Category moved from 'Cars and Trucks' to 'Vacuums'.If it was running okay before it went on charge and doesn't now, it is likely to be an electronic fault. They make it so that you can't run the vacuum whilst it is being charged. Try removing the battery for a few hours.
11/23/2021 3:40:40 PM •
Vacuums
•
Answered
on Nov 23, 2021
I am looking for a new water pump for my H2O Mop.
I took the pump apart and applied a small amount of silicone lubricant to the main o-ring. Bingo it now works lie new. It also saved me $65.00 which was the price of a new main body(what a ripoff).
11/21/2021 11:55:01 PM •
Vacuums
•
Answered
on Nov 21, 2021
Hi my vax rapide ultra
No it should only spray when the trigger is pressed. After spraying you go over the area to suck the water out. The valve on the trigger is faulty. I found this
I had the same problem, after buying a new clean water tank the problem was still there. I decided to see how it works and discovered the little shut off valve that the trigger operates is sticking in the open position. I am now trying to find a new valve.
Alan
October 2014
It seems to have its fair share of issues!
https://www.google.com/search?q=vax+rapide+ultra+carpet+cleaner+continually+sprays+water
..
11/19/2021 3:47:57 AM •
Vacuums
•
Answered
on Nov 19, 2021
Loose cable vax power 3
Try 'tightening' the screws first even if just a bit. This can possibly break them loose so you can remove them with the normal counter-clockwise motion.
11/16/2021 12:32:35 PM •
Vacuums
•
Answered
on Nov 16, 2021
The prefilter and the hepa lights are blinking-and i did add a new filter?
There might be a restriction of air flow. DId you know you can wash some HEPA filter out. Only ones made of fiberglass can be washed and reused. Cardboard HEPA filters should never be washed. Water will ruin the filters. When ever a vacuum cleaner looses suction, the foam (and or) felt filters are to blame not the HEPA's.
11/14/2021 3:47:00 AM •
Vacuums
•
Answered
on Nov 14, 2021
Belt keeps breaking after
Each vacuum cleaner manufacturer produces specific belts for specific machines. An incompatible belt installed on the vacuum cleaner will cause the belt to break or burn. The belt must be installed according to manufacturer directions for best performance, or the belt will chafe against the interior housing parts and break prematurely.Sharp debris, a low height adjustment setting or vacuuming up rug corners may cause the rubber belt to snap or wear prematurely. Check the height adjustment for the vacuum, and use a higher setting for plush rugs. Avoid vacuuming sharp objects and corners of the rug.
11/7/2021 1:05:18 PM •
Vacuums
•
Answered
on Nov 07, 2021
Proheat 25a3 sprays at tool handle will not spray at floor
The heater is likely clogged with soap gunk. The water for the upholstery tool does not go through the heater in you model. You can sometimes get it running again by putting vinegar in the tank and trying to flush it through and get it to dissolve or flush out the obstruction. It can take a few days or weeks of leaving the vinegar in the machine. Usually the obstruction must be removed by taking the heater out and cleaning it. The heater is in the handle. You can unscrew the handle and separate the front and back to access the heater.
If you can get the water flowing again you can keep it from happening again by not putting soap in the machine. Some models will not dispense water without something in the soap tank but you can put in water. If you put soap in the machine it is spraying the soap and water on to the carpet and immediately extracting it back out, it will still clean but not as well as if you would allow a few minutes dwell time to soften and loosen the oily sticky soils.
The best way to clean a carpet is by using a pre-conditioner (basically the soap) mixed into hot water and sprayed onto the carpet after it had been thoroughly vacuumed to remove as much dry soil and debris as possible. Allow a few minutes dwell time and flush out with fresh clean water. Your carpet will be cleaner and stay clean longer because you got it cleaner but also you rinsed out the soap.
My professional carpet cleaning business also evolved into a vacuum cleaner sales and service center. I am putting a how-to guide on my website and offering professional carpet cleaning tips and supplies to the do it yourself homeowner. Using the tips you will be able to clean your own carpets as well as or better than many professional cleaners. Visit ThatVacGuy.com. I will have it online very soon and will be updating it frequently.
11/7/2021 12:22:57 PM •
Vacuums
•
Answered
on Nov 07, 2021
Not finding what you are looking for?