20 Most Recent Johnson Minn Kota Mk 25 & Mk 35 On Board Maintainersstyle: Mk 35 - Page 5 Questions & Answers

Try trubleshooting with your repair manual Outboard Motors Boat Parts Marine Engines Inboard Boat Motor

you tube link https://youtu.be/kGEC8U88oV4 (copy paste) cdielectronics

Change lower unit lube, use fresh gas mixture with added Seafoam. Run as before, but longer. You can download manual from the web. Has P.M. instructions.

Spray clean the carb(s). Put in fresh gas and oil. Run Johnson cleaner in tank of gas.

Usually a plate on the transom.

For minor tune-up. Remove, clean or replace spark plugs. Use Johnson recommened fuel additive and recommended fuel type. Replace lower unit grease. Spray clean carburetor. Check fuel line and filter. check water pump function.

Try synchronizing the carburetors.

aprox. 60kgs

contact the manufacturer for that specification logically it will depend on the mass inside the vessel

2 stroke , excessive oil in mix and it is settling out after the fuel evaporates off 4 strokes the unit should be left in the drive position when not used

Under the lower carb, you'll find the linkage connector. There is a screw, holding a lever on the shift lever ( coming from the SB side ). Unscrew a few urns and you'll be able to slide the lever to free the vertical shift rod. You'll gain better access with the removal of the air intake baffle and the lower carburettor.

Yes, but not like other 'standard' head gaskets. This engine generation uses simple O-rings as head gaskets...

https://goneoutdoors.com/set-idle-johnson-outboard-7639140.html