20 Most Recent Electrolux Epic 6500 / 7000 legacy vacuum hose grey - Page 2 Questions & Answers

sounds like a clog /debris blocking brush from turning and belt slipping

the discovery electrolux are different. :) The top comes off, not the bottom like other vacuums. After taking the screws out, turn the vacuum on its side (vacuum handle to your left, front of vacuum to your right when looking at bottom). There are two rectangular holes, one on top above the wheel and one on bottom below the other wheel. Place a flat head screw driver in one of the holes and pry gently, pushing handle of screwdriver toward your right. At same time pull up on top plastic of vacuum. Do the same thing for the other side. Top should come off. Best to you.

I can't find a pares schematic for it. We are in North America and Google leads me to believe it is a model for New Zealand? Go to where you bought the motor and see if it lists a Thermal Fuse? https://www.google.com/search?q=Electrolux+UltraSilencer+ZUS3962%2C+parts ..

A thermostat in electronics general mean that there is a overheating issue..

check for clog --bag damage

improper connection of bag

Either the belt shredded or a thermal overload fuse has blown. Find a local vacuum place and take it in. Model details https://www.vacuumland.org/cgi-bin/TD/TD-VIEWTHREADM.cgi?38214_22 https://www.google.com/search?q=electrolux+%28ultralux+driclean%29 ..

Sure, Disconnect the two wires going directly to the motor. Then apply line voltage directly to the motor terminals. If motor does not turn it is defective - check the brushes for wear or bad contact. If motor runs then the electronics are bogus.

check hose for clog

Try somewhere like this https://www.centralvacuumdirect.com/Electrolux-Model-1590-s/2944.htm or here https://www.centralvacuumonline.com/products/electrolux/ ..

Does it stop and open up by itself when it over heats? It sounds like you did everything you could. The over heat sensor is too sensitive and may need replaced. I had one like that. The bag lid would pop open when the vacuum cleaner is hot.

Here apparently https://www.google.com/search?q=+Electrolux+cleaner+wax ..

The best Rim edge protectors you can get from Wheel Bands just take a look on them you will like them for sure because I have used them.

@Lenora Martucci - I have the same question. I cannot find where the charger is supposed to plug into either the stand or the vacuum itself. It is maddening

It can be on a sticker or raise letters on the plastic housing.

Ask you computer for a part

POSSIBLY ONLY THRU YOUR LOCAL RETAILER

Vacuum presumably? No, a new hose won't provide a cure to a non-working vac. Not uncommon for portable tools and appliances to stop working. About 7 times out of ten the fault is traced to an internal break in the power cord, usually within a couple of feet of one end or the other.

https://www.youtube.com/watch?v=-qOv5OpFaTQ

https://www.weeklytools.com/category/vacuum-cleaner/ With the growth of technology, vacuum cleaners' importance to keep your beloved home clean is endless. A machine can be disabled. But there is a solution. Following a few simple steps will help you to repair a damaged vacuum cleaner at home. So, Let's discuss Vacuum Cleaner Repair. If your vacuum can't work like before,