Sears Kenmore Elite Electric Dryer 69278 - Answered Questions & Fixed issues


The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes. If the code returns after plugging the washer back in, then the electronic machine control board will need to be replaced.
You can order a new control board from the Sears PartsDirect website.
http://www.searspartsdirect.com/partsdir...
Here's how to do it: http://media.fotki.com/1_p,wkwdftgtbkdgf...


Error code on dryer F01 - Kenmore Elite HE3 Dryer - iFixit

https://www.ifixit.com/.../Error+code+on+dryer+F01 Traduire cette page The F01 indicates a failed electronic machine control board. This error code can ... The Kenmore Elite HE3 is 7.2 cu. ft. capacity electric dryer by Kenmore.

Dryer Sears / Kenmore HE3 - F01 Error Code Main Circuit ...

2q==? 7:35 https://www.youtube.com/watch?v=eWqrn5klxm0 20 avr. 2015 - Ajout? par Jim Dandy Sears Kenmore Dryer Model HE3 - F01 Error Code. Main Circuit Board Repair - Electronic Control Board ...

Error code F1 on Kenmore HE2 electric dryer appeared ...

www.shopyourway.com > ... > Questions Traduire cette page Sears Kenmore HE2 electric dryer; model #11087571601. F1 error message appeared ... Power it back up and see if you still get the F01 error code. If not, then I ...

What does the error code F-01 mean on my Kenmore front ...

www.shopyourway.com > ... > Questions Traduire cette page By unplugging and plugging in the electrical cord, I got the dryer to work again. ... What does the error code F-01 mean on my Kenmore front loaded HE2 dryer? ... My kenmore washing machine 110.46462500 is flashing an error code F.01 ...

Error code on dryer F01 - Kenmore Elite HE3 Dryer - iFixit

https://www.ifixit.com/.../Error+code+on+dryer+F01 Traduire cette page The F01 indicates a failed electronic machine control board. This error code can ... The Kenmore Elite HE3 is 7.2 cu. ft. capacity electric dryer by Kenmore.

Dryer Sears / Kenmore HE3 - F01 Error Code Main Circuit ...

2q==? 7:35 https://www.youtube.com/watch?v=eWqrn5klxm0 20 avr. 2015 - Ajout? par Jim Dandy Sears Kenmore Dryer Model HE3 - F01 Error Code. Main Circuit Board Repair - Electronic Control Board ...

Error code F1 on Kenmore HE2 electric dryer appeared ...

www.shopyourway.com > ... > Questions Traduire cette page Sears Kenmore HE2 electric dryer; model #11087571601. F1 error message appeared ... Power it back up and see if you still get the F01 error code. If not, then I ...

What does the error code F-01 mean on my Kenmore front ...

www.shopyourway.com > ... > Questions Traduire cette page By unplugging and plugging in the electrical cord, I got the dryer to work again. ... What does the error code F-01 mean on my Kenmore front loaded HE2 dryer? ... My kenmore washing machine 110.46462500 is flashing an error code F.01 ...

Sears Kenmore... | Answered on May 14, 2016 | 809 views


This would indicate you have a lint build up somewhere in your exhaust system. The best way is to disassemble the unit and completely clean the unit. Also remove the exhaust hose and make certain it is clear all the way through and that the exit door is not blocked closed or plugged inside. I normally do this annually and then use a long brush to clean monthly to maintain a safe, functioning unit.

Sears Kenmore... | Answered on Nov 07, 2015 | 80 views


this sounds like someone has switched the wires on the door switch.

Sears Kenmore... | Answered on Aug 28, 2015 | 51 views


If light stays on when fully closed, door switch needs replacement, easily removed. Short term fix, disconnect the switch and tape the two spades together. Warning! Dryer will run even with door open.

Sears Kenmore... | Answered on Dec 02, 2014 | 106 views


Could be either the heating element or one of the sensors on the dryer.
Try cleaning out the main duct along with the filter on the top or inside

Sears Kenmore... | Answered on May 27, 2014 | 58 views


It is most likely the water pump on the washing machine. Check the hot and cold hose and make sure there are round gaskets on the inside of them and that they are tight on the hot and cold valves.
Also check the drain hose that it doesn't have any holes in it and that the hose is far enough down into the drain . If all that's ok, it's your water pump.

Sears Kenmore... | Answered on May 27, 2014 | 47 views


It could be possibly the belt. or if not, possibly a wire grounding out.
Most likely the belt. If the motors on a bind or going bad, it can smell like that also

Sears Dryers | Answered on May 27, 2014 | 112 views


element or stats

Sears Dryers | Answered on Apr 03, 2014 | 36 views


The heating element is burned out and needs to be replaced

Sears Dryers | Answered on Apr 03, 2014 | 71 views


replace timer

Sears Dryers | Answered on Nov 11, 2012 | 47 views


HOW WOULD ANY ONE GUESS WHAT YOU HAVE ASK THE MFG ONCE

Dryers | Answered Yesterday | 23 views


belt or drum roller issues

Dryers | Answered 2 days ago | 15 views


THERE IS NO RESET

Dryers | Answered on Jan 14, 2020 | 22 views


Either your switch, relay, Resistor or blower motor is bad. You can test them all.

Dryers | Answered on Jan 13, 2020 | 27 views


then call your local repair shop if you can not figure out how to get to it

Dryers | Answered on Jan 10, 2020 | 23 views


Buy yourself a high current in line switch.
Have some one take the cord out for you.
Place the in line switch in the socket and plug in the cord.
You don't have to take the cord out.
Only switch the in line switch off.

Dryers | Answered on Jan 10, 2020 | 24 views


Think Air FLOW. Air flow actually cools during normal use, so if flow is restricted, temps go beyond limits. Not what you want.
Here is an easy test: Pull dryer away enough to pull the exhaust hose off... Activate the dryer and form an opinion of the volume of air flow out of the back of the dryer.
Turn off, hook up the hose, Turn on again, go outside and likely you will find substantially lower air flow. I have seen installs that use a grill on the exit from the house. These clog up almost immediately.
Get the air flow working, your drying will be better.
My bet is something is clogged.

Dryers | Answered on Jan 08, 2020 | 19 views

Not finding what you are looking for?
Sears Kenmore Elite Electric Dryer 69278 Logo

10 questions posted

Ask a Question

Usually answered in minutes!

Top Sears Dryers Experts

Andrew Taylor
Andrew Taylor

Level 3 Expert

30331 Answers

James Steuber
James Steuber

Level 1 Expert

30 Answers

Brad Brown

Level 3 Expert

18136 Answers

Are you a Sears Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...