Top 20 Rowenta IS9100 1550W Precision Valet Commercial Garment Steamer w/ Retractable Cord Questions & Answers

Check the manual. You can always using some duct tape to cap the filling hole and see if it turns on.

Distilled water and filtered water are not the same. Distilled water is water that has been boiled then condensed so that most of the impurities that cause water hardness (Sodium, Calcium, etc.) have been removed. Filtering does not remove these which is why your iron will clog up much quicker. Same applies to your car battery, distilled water only! To clean it mix "Lime Away" with water about 1/4 cup with water every 6 months or so, then rinse with clean water a few times to get rid of the green color, steam until it comes out clear again..

Make sure you didn't knock off a wire to the heating element when you had it open. Also put a couple of cups of whitevinnegar in it and leave it for an hour or two. This will dissolve the scale build up. If it doesn't get hot thenthe element is probably burned out. There is a limit switch held against the tank too. It can stop the heating element if it goes bad.

Get some help here:http://www.rowentausa.com/rowenta/frame.aspx?page=http://www.rowentausa.com/rowenta/consumer_care/consumer_care/consumerCare.aspxor here:http://www.appliancepartspros.com/search.aspx?q=rowenta%20iron%20parts

You fill it from the hole in the nose. It comes with a small container that has a pouring lip. https://www.google.com/search?q=Rowenta+model+DE-871B+manual ..

replace it --switch fail

Page 5 of the manual onwards Lenora https://images-na.ssl-images-amazon.com/images/I/81Qca7gcYWS.pdf https://www.rowenta.ca/en/instructions-for-use/Products/Linen-care/Garment-steamer/csc/GarmentSteamer ..

There is an issue with the irons thermostat. You will need to buy a new clothing iron.

To open the Rowenta Superpress 050 iron, you should first unplug the iron from the power source for safety. Then, locate the water reservoir button on the top of the iron. The button is usually located near the back of the iron. To open the reservoir, you need to push the button inward and turn it counter-clockwise. This will release the reservoir from the iron's body, allowing you to fill it with water. After filling the reservoir with water, you can reattach it to the iron by aligning it with the body and turning the button clockwise until it clicks into place. Remember to never fill the reservoir above the maximum fill line, as this can cause the iron to leak water or even cause damage to the iron.

check out the videos that show how it's done. https://www.google.com/search?q=Rowenta+1700+iron+replace+damaged+power+cord ..

To try and seal the water leak will possibly render the appliance dangerous. I would speak to Rowenta and ask the question. They may well extend the warranty if you suggest it wasn't used for say a few weeks after purchase etc.

Question edited for clarity. Question moved to correct category. The search query really need the numerical model number. https://www.google.com/search?q=Rowenta+Inox+Surfline+manual ..

RCD or MCB that is tripping? If MCB the iron is overloading the circuit, usually a short circuit and is often related to the power cord. If RCD power is escaping from the circuit to ground and is usually caused by an internal water leak.

They are built to shut off after about 30 sec or so if the iron is not moving and the iron is in pressing position (sole plate down). They shut off if they are not moving and standing with the sole plate vertical, in about 5 minutes. If you move the iron (like ironing) they reheat. If it doing something else the electronic control is defective. It is cheaper to replace than repair.

Similar models manual: https://www.rowentausa.com/instructions-for-use/Products/Linen-care/Steam-generator/Compact-Steam/csp/1830006489 https://www.rowentausa.com/instructions-for-use/LINEN-CARE/STEAM-STATION/COMPACT-STEAM-STATION-DG7530/csp/1830005479 https://www.rowentausa.com/instructions-for-use/LINEN-CARE/STEAM-STATION/PERFECT-STEAM-STATION-DG8520/csp/1830005299

https://www.rowentausa.com/consumer-services/contact-us https://www.rowentausa.com/consumer-services/warranty-and-repairs/repairers There does not appear to be an official repair center in Nebraska. Contact the manufacturer using the links above to request assistance, please.

on of switch not working

need a meter and check the unit for short

There is no repair parts so replace it

Pour in some vinegar (half) and some water (half) in the machine. Turn it on and let it run a bit. Make sure to do it outside since it smells badly. After that, rinse a few times before use.