Top 20 Stoves Premier 600GRa Gas Single Oven Questions & Answers

as it is when your oven runs normally it usually does an on and off type of running in which the ignitor lights the flame from the gas which stays on until the oven tempreture sensor tells the control board that the oven is hot enough at which time it shuts off the gas until the oven starts to go maybe 10-15 degrees below the tempreture at which time it would let the gas go through the line again and turn on the ignitor try checking your ignitor usually if you stick an amp meter on them should be drawing 3.3 amps plz remember to shut off the gas from the gas shut of valve in the rear of the machine before measureing for the amps hope this helps

make sure the thermocouple is positioned above pilot light this part needs to be heated up by the pilot light to keep gas going to the pilot light. if the thermocouple is positioned above pilot light and it doesn't stay light, replace thermocouple.

Hi,
Check out this tip... just because you get a glow from the ignitor, that does not mean that it is not bad...

http://www.fixya.com/support/r3663023-oven_not_working_or_oven_not_heating

heatman101

I got technician locally to came and sort out. He says it can happen but often but there is a chance and I was the unlucky one.

air pressure switch broken oven thinks the fan is not working and turns it self off.

Try unpluging the oven or shut off at breaker for 30 seconds to reset it.

https://www.manualslib.com/manual/1371105/Stoves-El616.html?page=8#manual Bestt to you

If you have paid for warranty insurance, read the small print. I think you will find, if it is not repairable, they must replace it with an equal or better unit.

need to diagnosis problem first

not a car moved yah kitchen stove (cantina)? no maker of stove and model told sorry, ask maker for manuals. mucho gusto

Probably the igniter is defective.

NO COUNTRY TOLD THE MANUAL SHOWS CONTACTS IN YOUR LOST MANUAL https://www.manualslib.com/manual/938924/Aeg-Hk634030fb.html?page=28&term=CONTACT&selected=20#manual

Stoves-spares.co.uk seems to have plastic part(s)Occasionally parts become obsolete or redesigned for cost reasons. Metal hinge assembly from website BuySpares.com Please check the diagram & parts list if available because on certain models the original door & hinges are obsolete and you will need to order a new door as well as these are the new type hingesYou may be able to just replace the springs, unless your hinges themselves are damaged.

notify the owner for fixing it

CONTACTTHE MANUFACTURER THRU A DEALER

usually a faulty oven thermostat

Sometimes these controls are custom and need to obtain an exact fit OWM replacment (rather than a generic part.)

If your in the UK, try contacting

B Grade Domestics,
1, Armscroft Road, Barnwood, 
Gloucester. GL2 0SQ,

UKSupport: 01452341595E
mail: [email protected]

https://woodstoves.net/documents/breckwell/BigE-2-Manual.pdf https://www.hunker.com/13407443/how-to-troubleshoot-a-breckwell-pellet-stove

check that it is not in auto or timer mode

Check how you wired the resistor. The resistor controls the speed of the fan. If its wired wrong, you will get the wrong speeds and the resistor will get very hot. Its normal for them to get warm but not so hot they start to burn. There should be a wiring diagram somewhere on the stove so you can check and confirm if one or more of the wires have been put on back to front.