Audiovox Prestige Cl100 Carlink System - Answered Questions & Fixed issues
I have a carlink app on my sprint evo to start my
You have to purchase the Link Module from your local alarm dealer and have them install it onto your existing audiovox alarm unit. The Link Module will come with it's own SIM ID and the 4 digit PASSCODE will be provided to you by the dealer for activations. You can't just download the app and expect the app to know what type of car or where your car is located in the US to remotely start it.
1/22/2011 11:07:23 PM •
Audiovox...
•
Answered
on Jan 22, 2011
•
1,109 views
Where do i find my
i have a prestige auto start and alarm is came with a car that i just bought not too long ago i dont like that the car locks by itself and i dont know how to change that. i also have a android phone and trying to set that up on my android phone and i dont know the sim id and passcode
7/26/2012 10:25:03 PM •
Audiovox...
•
Answered
on Jul 26, 2012
•
3,064 views
What are the input wires on a audiovox amp777
The Audiovox AMP777 is a 4-channel power amplifier, and the input wires will depend on the audio source you are using. Typically, the amplifier will have RCA input jacks for left and right channels, and you would use RCA cables to connect the audio source to the amplifier. Some amplifiers also have a high-level input option, which would allow you to connect speaker wires directly to the amplifier's input terminals. However, it's always best to consult the user manual or contact Audiovox support for specific wiring instructions for your amplifier model.
2/24/2023 9:29:26 PM •
Audiovox Car...
•
Answered
on Feb 24, 2023
•
62 views
My cd runs but will not play the cd
Quite common problem. Repair it or replace your player if repair cost is too high. Personally, I stopped using CD players time ago: I use a mp3 player.
5/13/2015 3:23:03 PM •
Audiovox Car...
•
Answered
on May 13, 2015
•
238 views
Red light is on and subs won't play
sounds like the amp is in protection mode. try disconnecting the subs and see it the light changes to green. if it does then the subs are your problem. if the light was allways red while it was working then the subs may be disconnected inside the box or have gone bad. try using a diffrent speaker and connect to the amp.
12/18/2014 2:55:53 PM •
Audiovox Car...
•
Answered
on Dec 18, 2014
•
231 views
My dual dvd player starts the movie over after i go over a bump
Bring it back to where you bought it and buy a better name. There may be a firmware update available for the unit which improves it's behavior and recovery. If you're not able to return it, perhaps you can isolate it from bumps by placing it on a piece of foam. I'm sure it may be very frustrating.
12/14/2013 4:55:00 AM •
Audiovox Car...
•
Answered
on Dec 14, 2013
•
54 views
Replace speakers in dashboard
Take the plastic pillar covers off of both sides of the car, remove the screws near the air vent outlets on each side, use a panel removal tool to unclip at each side and front of the upper dash panel and pull rearward from the front of the upper panel until the clips are cleared and lift and remove the upper dash panel. Remove the speakers covers and the screws holding in the speakers, disconnect speaker wires. replace with new speakers and then put everything back in the same order after testing the new speakers.
10/4/2011 9:24:29 PM •
Audiovox Car...
•
Answered
on Oct 04, 2011
•
152 views
Distortion when volume is high
turn gain down. or (input) its too high or you have your volume up way too high and your head unit is sending a clipped signal which will kill your speakers and cause distortion
9/13/2011 2:29:53 AM •
Audiovox Car...
•
Answered
on Sep 13, 2011
•
67 views
Not finding what you are looking for?