20 Most Recent JBL PSW-D110 Speaker - Page 5 Questions & Answers

Maybe because they are difficult to find now a days and there are a lot of them around too.

Check your charger point

The controls for the JBL Charge 3 are up top and you have volume up and down, Bluetooth pair, power, play/pause, and a button to link this device to other JBL speakers. There is no skip button, but if you hit the play button twice quickly it will skip to the next song

Only from JBL

The service manual is posted in this but if you dont have the test gear that is required, it is not much use. https://www.scribd.com/document/143852098/PB12-JBL-pdf

https://www.jblpro.com/ProductAttachments/EON%20600%20Users%20Guide.pdf

Assuming Bluetooth mode. Insure Bluetooth is enabled on the iPad and the JBL and that they are in the pairing mode.

Sometimes I find it necessary to restart a device to get its Bluetooth pairing mode to connect to the device I am trying to connect it to, such as a speaker or even my car.

Only if your tv has bluetooth

Try doing default factory settings. Step 1. Press the "Power" button located on the top center part of your JBL Charge 4 Bluetooth speaker. The speaker will be powered on when the LED backlight under the Power button is lit. Step 2. Hold down the "Bluetooth" and "Volume Up" buttons at the same time for roughly three seconds. The Volume Up button looks like a plus sign. Additionally, it's important to hold down the "Bluetooth" button in the center of the device next to the Power button, as it's easier to hold down. After three seconds, the LED ring around the Power and Bluetooth buttons will briefly light up before the JBL Charge 4 powers down. Step 3. Press the "Power" button again to turn the JBL Charge 4 Bluetooth speaker back on. The Charge 4 will instantly turn on in Discovery mode, with the Bluetooth LED blinking on and off, and the speaker making a pinging sound. This confirms that you've successfully reset your JBL Charge 4 to its default factory settings. You'll need to pair or re-pair any devices you want to play audio through the JBL Charge 4 speakers with the device.

Here is the link below for JBL Charge CE1588

That is a bluetooth speaker sir. Standard device. ANY device with bluetooth should be able to use the speaker with no drivers other than the ones included on the playing device

Did you ever find out what was wrong? Mine is doing this now.

Just visit the site linked here; only and if you're technically qualified. If not, contact any service technician to repair this set. https://electronicshelponline.blogspot.com/ If you're aware, you'll get something. If not nothing. OK?

If your speaker supports Bluetooth. Use the screenshots below to connect to your device. If not, you can use a wire from your iPhone to the speaker. it looks like the last screenshot below. On your phone... Go to Settings and then Bluetooth. Turn on Bluetooth. Look for your JBL device under "OTHER DEVICES" and tap on it to connect. On your speaker. Turn on pairing mode for your JBL deivce Find your JBL device on your phone or laptop and pair them Confirm successful pairing JBL speakers typically have a dedicated Bluetooth button to use to pair your speaker.

This sounds like it could be the input board. We have them in stock. http://reconingspeakers.com/product/jbl-prx710-input-module-5032671/#prettyPhoto