20 Most Recent
Plantronics Explorer 220 Bluetooth Headset Wireless Headset - Page 4 Questions & Answers
How to find pin number
Please, take a look at
these generic tips I posted a long time ago. Hope they might be helpful to you, somehow.Anyway, please, let me know if you need further assistance. In this case, make sure to specify both your heaset and phone makers and models.Regards,Carlos
Does explorer 230 pair with nokia 2600
Hi,
the explorer 230 blue tooth can be paired with the Nokia phone if only the blue tooth tooth device is a universal blue tooth.
Universal blue tooth can work with any phone no matter the model.So check the blue tooth if it is a universal blue tooth, try it with the phone and see if it will work.
Have a nice day
My iphone can not the device
Turn on the headset by pressing and holding the call control button for 5-6 seconds until the indicator LED flashes red/blue. Release the call control button The Explorer 220 headset is now in pairing mode.
Is there a reset botton on the Plantronics 2XX?
I've successfully reset the plantronics explorer 210 by holding the big button on the outside (by the flashing light) down for 5-10 seconds. I wait until the light starts flashing red/blue instead of just blue.
Light stays blue and it dont turn off
I've seen this happen on a lot of other online forums for this same headset. Even on the Plantronics site itself. It says it is a defective unit and you should take it back to the retailer you purchased it from or contact them directly.
I can't connect with my
Please follow the detailed instructions below for the proper pairing of the headset with your phone.
CHARGING
Before using, you must first charge your headset.
20 minutes = minimum charge
2 hours = full charge
Light is solid red when battery is charging.
NOTE For the best user experience, keep your headset fully charged.
CAUTION Do not use headset while charging and do not connect the charger while the headset is in use.
POWERING
Press the control button for 2 seconds to power on. Press the control button for 3 seconds to power off.
PAIRING
Step One:
Prepare Phone- Turn on Bluetooth For most phones, go to Settings/Tools menu and select Bluetooth or Connectivity and select "On."
Step Two:
Prepare Headset- Pairing Mode Begin with headset turned off. Turn headset on (hold call control button for four seconds until the light flashes blue) and it will automatically go into pairing mode, flashing red and blue.
Step Three:
Pairing- Add Headset to Phone For most phones, go to Settings/Tools
> Bluetooth > Search or Add a Device, then Select "220Plantronics." For passkey enter
0000. Headset will flash blue when paired successfully. It is now powered on and ready to use.
NOTE: Normally you only need to pair the headset and handset once. If headset has been previously paired with another device, follow pairing instructions below.
If headset has been previously paired with another device, please follow these instructions for pairing a second time. Be sure the headset is fully charged.
Begin with headset turned off.
1. Press and hold down the call control button for 8 seconds until the headset status
indicator begins to flash blue then red.The headset is now in pairing mode for the next 120 seconds.
2. While the headset is flashing,use the phone menu to search for Bluetooth devices and select "220Plantronics."
3. When prompted for a passkey, enter 0000. Headset will flash blue when paired successfully.
NOTE: The headset can pair to multiple Bluetooth devices, but will only connect to one device at a time. The headset will automatically connect to the last device to which it was connected.
Please don't forget to rate me if satisfied.Thanks for choosing Fixya.Good Luck.
Not finding what you are looking for?