Bosch Nexxt 500 Plus WFMC5301UC - Page 9 - Answered Questions & Fixed issues
BOSCH MAXX CLASSIC E2 error reset, has water and drained, but the machine did not run/spin.
FROM FIXYA
Sanja Salatic NOV 29, 2009
The e2 error is a generic error that the machine shows if it's been overloaded or if the load becomes unbalanced during a wash cycle.
to fix you must do a master reset of the washing machine.
1. Close the door and make sure the dial is pointing to the "OFF" function
2. Hold the Start/Pause button and turn the dial anti clockwise (to the left) to the "express 15 min" program at the same time.
3. Hold the Start/Pause button for a minute (the e2 message is meant to start flashing after a minute of holding the button down however with my washing machine this didn't happen)
4. Release the button and turn the dial back to the "Off" function.
5. Select any program and the message should not be appearing.
--------------------------
5/9/2022 12:39:26 PM •
Bosch Washing...
•
Answered
on May 09, 2022
•
2,940 views
Why does my soap dispenser does not work on my Bosch dishwasher?
Hi, I know it's kind of a silly thing but when loading the machine make sure nothing is jammed against the dispenser preventing it from opening. I've run into that a few times and people looked at me like I had two heads but when I showed up to look at the machine,it was loaded like thanksgiving dinner was just over. If that is not the issue then it's either the dispenser itself that is broken or it's not getting power from the board. Either problem will require getting into the door of the machine and running a test program. I would call a local appliance repair company as these tests require the machine to be powered up and specific tools. Hope that helps.
10/17/2019 11:59:13 AM •
Bosch Washing...
•
Answered
on Oct 17, 2019
•
156 views
Cannot open bosch Avantixx 6 door flashing f 21
Original advice in 2014 from Kenjo, on another website:
f21 is worn brushes in the motor replace them and to reset the f21 code.... close the door, turn timer dial to position 8 going clockwise, hold in the spin speed button whilst turning dial to position 9 let go of spin speed button and return dial to off position.
Not finding what you are looking for?