20 Most Recent Kenmore Top Freezer Refrigerator - Page 4 Questions & Answers

Pop out the front cover, tighten screws, push cover back on.

http://produtools.com/d/manuals.php Go to this website and download it is COMPLETLY SAFE!!!!

You have a short in the wiring going to the door. You will need to track it down.

It not to hard to do, if you have some mechanical ability and some basic household tools. First unplug the fridge. Then remove the contents of freezer so you can remove the back panel in the freezer compartment. You may need to remove the shelving in order to get to the back panel. Once the panel is removed, you should be able to see the evap motor. It usually mounted with a couple of bolts or screws. Loosen the bolts, then remove the wires. The wires may be attached with wire nuts or they may have some crimp connectors. Either remove the wire nuts or the connectors and reattach wires to the new motor. If your new motor does not come with a fan, simply pull the old fan off and press it onto the shaft of the new motor. Install the new motor with the bolts or screws. Plug in the fridge, if you have attached the wires correctly the fan should spin, otherwise unplug and check your work. Replace the panel and the food and plug in the fridge. Hope this helps you.

You might have a water build up.

i have had luck cleaning refrige drain lines in 2 ways,make sure theres no ice in the drain line just below the freezer drain pan,then try a piece of plastic hose available from any hardware or home stores and feed it down the drain under the drain pan and blow into the hose to pressurize the line it may dislodge the blockage,if not,try a piece of wire and rat the line out till water drains