20 Most Recent
Dell 1201MP Projector - Page 2 Questions & Answers
The lamp is not coming on. This is the 3rd time
Do you have any fault lights lit or blinking? LAMP or TEMP?
LAMP light is solid orange - If the Lamp light is solid orange, replace the lamp.
TEMP light is solid orange - The projector has overheated. The display automatically shuts down. Turn the display on again after the projector cools down.
TEMP light is blinking orange - A projector fan has failed and the projector automatically shuts down
Sounds like you have a fauly lamp or possibly a bad fan - it depends on what fault lights are lit.
If the lamp is going out and you don't see any fault lights lit then you probably have a control board failure.
The projector only displays in
Basically the first thing for you to check will be the color settings. Try to adjust the color settings as the color may have been adjusted to the lowest.
Also try using an alternative cable to connect the projector often times these cables cause untold problems and make you spend lots of money for problems which do not exist.
Finally if your unit has NTSC/PAL compatibility switch check it.
Hope this solution has been helpful?
1201MP Projector in my daughter's
Clean the filters. Make sure that the vents are not blocked. fan are working? Make sure the lamp door is secured, Projector manufacturers will make the projector inoperable if the door isn't secured tightly. Reset the lamp timer. email me at
[email protected] if you need a manual.
Dell 1350cnw printer paper jam
Not sure if this will help, but I resolved mine in the end by opening the toner compartment and removing all of them then popping them back in. I also 'scrubbed' some sensors via a blue pullout bar in the toner area.When I started up the printer, I then held down the Red X button until it said 'ready to print'. It's working fine now.HTH,Tony
Not finding what you are looking for?