20 Most Recent Frigidaire FEF352 Electric Kitchen Range - Page 9 Questions & Answers

What is the model number?

Yes, the microwaves will still be contained,however it needs to be replaced. super glue will work if the original parts are broken or lost

The F50 code appears to indicate that the oven relay board can't get the status of the switches (door closed, motor door lock). Try unplugging the range to reset the control board. Next check the wiring harness. If there is nothing wrong with the wiring, then the oven relay board may be faulty. Please add a comment with the model of the Frigidaire range if you would like a parts diagram and other information. I hope this helps. Cindy Wells

The gas orifices for propane are different than LP gas. Are you trying to blow yourself up?

It is not based on time,. It uses temp sensors. When surface is cool enough it will go out..

This is going to require a new EOC, which is the control board. I attached a link that may help.

The first thing we want to do is disconnect all power to the range for 5 minutes. Turn the power back on and test. If that does not work it could be the induction generator or the relay board it would take some electrical testing to figure out which. I hope this was some help.

Code D81 is usually caused by a power surge of some type. The first thing to try is to unplug or shut off the power to the unit for 5 minutes and try it again.

That is a power fault. Your control board is bad.

Where is the office at to make the oven and smaller

1.Try disconnecting the electricity for 20 seconds, shut off the breaker in the breaker box to the oven. Then restoring it. 2.Try setting the oven into clean and starting it. Wait 30 seconds and cancel clean. Sometimes one of these methods work. Best to you

I suggest you lift off the burner ring and ensure there is no foreign matter in the area of the igniter. Observe whether the is a spark when you press the button to light the gas. It is possible that the ignition plug has failed, therefor you will need to purchse a replacement.

Shorted touchpad. Try unplugging for 5 minutes to see if it will reset

Here’s the link to Frigidaire answer center.

https://www.frigidaire.com/Owner-Center/Contact-Us/

just started 6 weeks ago and I've gotten 2 check for a total of $2,200...this is the best decision I made in a long time! "Thank you for giving me this extraordinary opportunity to make extra money from home. This extra cash has changed my life in so many ways, thank you!" Visit site:: SalaryHD­­.­­C­­o­­m

The F31 error code means that the control board detects the oven temperature probe circuit is shorted. If the sensor tests good, then you could have a bad control board or a short in the wiring.

Check elements and all wiring connections

There are screens under front of top just above door. Remove those and top should lift up and remove

f14 Looks like a keypad problem. First remove power for 10 minutes or so and then give it a try. This may reset the board. If this does nothing. Disconnect the unit from power, unplug the keypad at the control board and clean the connectors then reconnect it and give it a try. Use electronics cleaner or isopropyl alcohol and a tooth brush to clean them. Just make sure all the solvent has evaporated before reconnecting. If the ribbon cable is the type where just the insulation is removed (no connector) the contacts can be cleaned with a pencil eraser. Do not use an ink eraser as iit is too abrasive. If this does nothing Check it with a meter as shown in the tech sheet to confirm it is shot. If it is OK then the problem is probably on the control board itself. __________________ Here is the link to the pdf test sheet mentioned above. http://manuals.frigidaire.com/prodinfo_pdf/Springfield/316904001.pdf