20 Most Recent
Canon MP140 PHOTO AIO All-In-One InkJet Printer - Page 3 Questions & Answers
Mp140 printer- do I have
Yes both ink cartridges need to be installed in the printer for it to work.
You will either need to purchase new Canon ink cartridges for your printer or refill your old ones.
Take care!
damnor01
E3 message on my canon
Hello,
E3 error stands for paper jam. Unplug the printer completely from all cables. Lift it up, turn it upside down and shake it a bit to see if anything comes loose. Check
the rear access and front access using a flashlight to look for any
tiny paper scraps or anything else that could be hard to see. Try forcing a very thick piece of paper into the rollers to see if it dislodges anything. Finally try using a dampened lint free cloth to clean the rollers in the printer.
In case this won't help, then it sounds like a hardware damage. Probably a damaged roller.
Lucas
Error E6
Hi, try to press Stop/Reset button for few seconds and then release it. It shall back to normal after that. Hope it works for you. Good luck =)
E 5 error code
this is what your error means
E5-5
= The ink cartridges are not installed or a non-supported ink cartridge
is installed, or the ink cartridges are not installed properly.
are you using brand new supported ink cartridges?
are they in the right way?
Absorber is full
Absorber needs to be cleaned. Take it to a service center. It will be OK.
I need to install my
You can install it by downloading the printer software/driver from this link and use it for installation , just click
HERE and proceed with the download.
Hello all, I have MP 140 printer too, but it does
his
particular error had stumped me for a while, but I finally found the
cause. As others had pointed out before, it can have alot to do with
some obstruction in the print path, the gears, or ink on the clear
plastic encoder strip. You're on the right track - I found the the purge
cap (the white sliding mechanism that the print head parks to when it's
not in use) was not lubricated well enough from factory. If you
lubricate the sliders with some white grease (don't get it on the small
wipers or the black caps) the mechanism can now slide more freely, and
the unit can park the head properly without giving you the dreaded head
homing error 5100 (or E-2-2 on the LCD display) Keep in mind that this
repair will probably require you to remove the right panel off of the
printer to gain access to the purge mechanism. There are two screws
behind the printer, and two in front for each corresponding side panel
(the front screws are behind the grey front panel of the printer - open
the top cover to see the clips which hold the front cover on)
Not finding what you are looking for?