Hello - Before performing any maintenance or work on the dishwasher, please disconnect power to unit! Edges of door may pose a cut hazard, use gloves or a heavy cloth when grabbing edges.
Remove Covering (i.e. outer door, console, kickplate) to access load that is not switching.
>Is the electrical device connected to the harness? If <YES>
Loosen the screws on the C-arm, push the door down & tighten the screws to align the door with strike, is the unit a pull latch Model? If <YES> You may possibly need to order an angled striker Part # 154544601 (part number can be different depending on your model number). If <NO> Bend the striker down to align with the center of door slot.
If the electrical device is NOT connected to the harness; connect the harness to the electrical device. Replace all coverings and reconnect power to the unit.
Put the unit into water service test. Step through test and determine which Load is not switching.
Should this prove to be unsuccessful I suggest contacting a professional to move forward accurately.
Hi kelli kelly - From what you have described if the dishwasher switches to china mode, then there seems to be a communication problem with the main control board or wiring harness. I strongly suggest contacting a professional to move forward accurately and to properly diagnose the unit.
Hello - Since you have previously replaced the bottom gasket and issue continues I suggest contacting a professional to move forward accurately. The leak could possibly be coming from the drain motor/pump or a loose hose connection located underneath.
239 questions posted
Usually answered in minutes!
438 Questions
252 Questions
192 Questions
117 Questions
100 Questions