Jenn-Air JDB3610 Built-in Dishwasher - Answered Questions & Fixed issues

in the manual there is a sequence to unlock the control check the manual for the unlock sequence

If you have hard water, glasses can look spotted and cloudy even after cleaning. Sometimes changing the dishwasher detergent can help. The easiest solution to clearing up glasses that start to look cloudy is to add some vinegar to the bottom of the dishwasher before you start a cycle. Simply add 1 cup of white vinegar and it will clear up your glasses very well.
You should see marked improvement after the first time you do this. If they are not crystal clear then simply repeat the process until all of the cloudiness is gone. In fact I recommend to using a little vinegar in each cycle to maintain the clarity of the glass.
Note: you can pre-test this by rubbing some vinegar on an individual glass with a cloth. If you cannot remove the cloudiness by soaking it and rubbing vinegar on it then it is possible that the glass is etched due to harsh or cheap dishwasher detergent and vinegar will not solve the problem.

First perform a vinegar cycle wash in the dishwasher. Pour a cup of vinegar into the bottom of the dishwasher. Keep the temperature at the highest setting possible and perform a wash cycle.Then start using a dishwasher most probably that would solve the problem. If this does not solve the problem then there must be some parts worn out or faulty creating the problem.

There are many probable causes of failure .

To clean the dishes the water temperature is essential.It the water is not hot then the dishes will not be cleaned properly.So check the water temperature.

Also check the filter in your dishwasher.Clean the filter if there is accumulation of debris in the filter

If you are in an hard water zone , then try reducing the amount of detergent used and then try cleaning the dishes.

The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your dishwasher and removes the hard minerals that cause these spots. Very affordable and guaranteed to leave your dishes looking amazing every time.

Try cleaning the float switch (the little cylindrical thingy mounted to the bottom of the dishwasher toward the front). If that doesn't do it you may need to replace it. Before you do, consider the cost of the new switch, and the age of the dishwasher, then consider the cost of a new, more energy efficient dishwasher. You may just decide that you are better off just replacing the dishwasher.

POSSIBLY CONTROL BOARD BUT WE CAN NOT GUARENTEE IT SINCE WE CAN NOT DO THE TESTING NEEDED

The accumulator filter is below the spray arm radiant shield, guard and wash impeller and above the wash motor and pump. See part 7 on the diagram: https://www.partselect.com/Models/JDB2150AWP/Manufacturer/1/Sections/PUMP-AND-MOTOR/?ModelID=89671&ModelNum=JDB2150AWP&mfgModelNum=&ManufactureID=1&Selected=55866&Position=2&mfg=Maytag&Type=Washer&Mark=2 . There is also an over-pressure filter on the dishwasher feed tube. See part 2 here: https://www.partselect.com/Models/JDB2150AWP/Manufacturer/1/Sections/WATER-DISTRIBUTION-ASSEMBLY/?ModelID=262050&ModelNum=JDB2150AWP&mfgModelNum=&ManufactureID=1&Selected=55865&Position=6&mfg=Maytag&Type=Washer&Mark=6 . I hope this helps. Cindy Wells

Contacts in manual may also help. http://kitchen.manualsonline.com/manuals/mfg/jennair/dw860.html

Couple of things to check: there's a float that needs to more freely, make sure it does. There's dishwasher cleaning instructions in the operation manual. You may need to take the lower rack out, take off the spray arm to get at a filter, which you should clean and replace. Then you can try to run some white vinegar through a wash cycle. Jean Air has these instruction at their web site.

it is usually the panel that fails

Well, unfortunately, the last one I encountered like that, I had to replace the control board...

Unrelated, Jet dry is a surfactant to prevent water spots.

Specifically what lights are blinking? Do you have the child-lock (control-lock) turned on? If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Try aplianceprosparts.com , they have all the diagrams for upper , lower and middle racks , and doors also , I ordered some rollers for a jenn air dishwasher last week and they delivered the part very fast and that was regular shipping, also the best price around , some other web site had it for 50 bucks + taxes and I paid 38 bucks + taxes and s&h! good luck.

Free Jenn Air Dishwasher User Manuals ManualsOnline com

you may need to take it back and exchange it. It sounds to me like the dishwasher is not recognizing your commands which means that it has a bad control board. If you do not want to go through the trouble of that you can always get a technician to come out and replace it for you. That will cost more money. It is up to you though.

Unplug it or turn off the breaker for a minute.

hELLO THERE:
I would recommend first cleaning out all of the filters including the ones under the sprayer arms than i would check the pressure of the water going thru the system refer to the users manual or go to the manufactures website and view the pdf manual for troubleshooting
ok?
best regards michael

Open the door to the dishwasher. there should be a circular peice on the left or right side of the tub. it maybe stuck. if its stuck. the water won't shut-off.

you must contact to jENN-aIR FOR get customer support, about the material recommend. About some agent used, or if some bad design material from factory.God bless you