20 Most Recent Yamaha HTR-6030 Receiver - Page 9 Questions & Answers

It's in protection mode. Disconnect all speakers and hold the Tone and Straight buttons while hitting the power button. Hold all buttons down for 3 to 5 seconds. This will turn off protection mode. Now power down then back on. If you haven't damaged anything it should work fine. Make sure all speaker connections are good. Always power down the unit before making any speaker or other connections.

If you are in Pro Logic mode and play a stereo recording/film etc, there will be no rear sound. You need a Pro Logic recording to produce true rear sound.

That is unusual because the tracking laser is a lot less less power than the reading laser. You can try a Cleaning Disc, but you probably need Yamaha Service.

Question moved from Cars. Parts here https://www.google.com/search?q=Yamaha+AV+Receiver+RX-V481+parts ..

Question edited for full 'make model (what is is).Sounds like the aerial antenna is not connected. Check behind the unit and also the connector wherever it goes.

I would get it fixed at a Yamaha Service Centre, as you don't have the test equipment to find which failed component is causing it to shut down and protect itself. The only thing you might try is looking for bulging or split capacitors. That WOULD cause circuit protection, because they are power stores and smoothers.

Check speaker wires did not short out or the amplifier was not over driven. The usual cause to go into protect mode is a failed power stage.

Question edited for clarity. Question moved from Office Equipment. Did you connect the AM and FM Aerials to the rear of the unit? Page 10 of the manual refers. https://www.manualslib.com/manual/197298/Yamaha-Rx-V4-390.html?page=10#manual

Yamaha RX-V490 Manuals ' ManualsLib

https://www.manualslib.com > ... > Stereo Receiver Yamaha RX-V490 Pdf User Manuals. View online or download Yamaha RX-V490 Owner's Manual.

This is directly from the service manual for the R-N402: Hold the left preset button (<) and the bass (+) button and press the power button and then release. The receiver will disable the power protection and turn on in self-diagnostic mode. My device is working correctly now. :)

The laser that reads the disc's and the lens need to be replaced for your CD player.It cold be that the volume control has worn out and needs to be replaced.

You will need to send it in for repair is my assessment.

Question edited for clarity and spelling. In the link https://www.google.com/search?q=yamaha+rx-v640+factory+reset ..

Not all receivers will support an equalizer. If the receiver has a built in equalizer, another equalizer will not be supported.

Can you turn it on with the switch

Hi Craig, I don't think this is something you can fix yourself, I'd try an electronic service center

You need another remote, just buy one! $23 on Amazon. https://www.google.com/search?q=Yamaha+rx-v379+replacement+remote ..

You will find it has a power amplifier issue. Take it to an authorised Yamaha repair centre.

Follow the instructions that comes with the remote controller.

sadly no clue intermittent failure problems are hard to trouble shoot