Top 20 Sony KDL-32S3000 32 in. LCD Television Questions & Answers

Check the Video Amazon Fire TV Stick First Setup and Walkthrough If you wish to get some details; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis. http://electronicshelponline.blogspot.com/ Some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement.

1. Turn on the TV.
2. Wait approximately 40 seconds for the TV to completely start up.
3. On the TV remote control, press and hold the UP ARROW button

actually tv is not full hd & not sported play station signals through HDMI

check 5v regulator on cont board

Fuse is on power board near AC input connector. you needto open the back cover for this.

Tow times flashes [blinks] denotes a fault with its power supply regulator board. The output voltage come out from it might be less or more than normal. If you wish to get more details, check this link. http://electronicshelponline.blogspot.com/ Selecting the view option, either to Mosaic / Time slide, can be selected by the drop-down list, at the top left of the display window, will make surf easy. You can also do a search, by type in the brand name/model number/IC used, in the search box at the top right of the display window.

make a new HDMI errors which is in main board .

Just a copy from Sony: 5X Blink - TCON & HFR Failure The 5X blink protection mode indicates a communications error between the TCON/HFR board and the MT5388 microprocessor on the A-Board. First replace the TCON/HFR Board if the 5X protection mode blink pattern occurs. If the TCON/HFR Board does not repair the problem then replace the A-Board.

It sounds that the main digital board to your TV is faulty. Contact any experienced service technician.

the first place to be checked will be the power supply board look for bulging electrolytic capacitor. if no bad cap check shorted component at the inverter board of the screen back light.

Check and replace T'Con board.

you might want to unplug the set and a box or receiver if used for a while==plug back and see if the units reboot helps this problem or not===a box or external unit can cause this kind of problem.

Pick TV Remote Control and press Display button once, On-Screen display [AV2] will disappear.
Hope this will help.

The LCD Tv's processor has hung up due to some errors that have come into the memory. So to reset you can switch off and remove power to keep aside for an hour.
If the set does not power on after this reset then the software is corrupt and must be downloaded. seek help from Sony support.
http://support.sony-europe.com/repair/index.aspx?site=odw_en_GB

You can use a 3.5mm headphone jack to RCA cable, found here.Thanks, and have a great day!If my solution helped you, please don't forget to leave positive feedback!

If this happening when TV is viewed then it is possible that the auto shut off is active as no signal is detected by the processor and so is instructing to shut down.
However this fault is related to a problem in the signal detection circuit, if this happens with the auxially circuit- play station- then some logic gate is faulty which needs to process and detect the signal.
Remove power for few hours and see if the fault resets, if not the circuit needs a technical review.

B+ over voltage protection (OVP), unit goes to the standby mode then displays the 3 blink fault. This is also a problem in the power supply circuit, check T603 and R672.
Have you set the output voltage correctly?

The replacemant screen plus labor will cost you $300 (Screen can be $200 and up if you find one) and up. Screen is the most expensive part of the TV and very limited production, you may want to sell the boards on EBAY and use the money toward new TV.


Basic LCD monitor and TV troubleshooting guide: http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting http://www.fixya.com/support/r7406380-tv_training_manuals Failed TV and Monitors pictures: http://s807.photobucket.com/albums/yy352/budm Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague Parts: www.shopjimmy.com Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps. Or www.digikey.com, just make sure to use caps with low ESR, 105c, high ripple current and long life rating such as PANASONIC FM or FC series.