20 Most Recent Jenn-Air 30 in. CCE3401 Electric Cooktop - Page 2 Questions & Answers

I'm Bruce of DeBruce Polish, our new polish is non-toxic and odorless and non abrasive, should take care of your problem. We designed it for stainless steel, and have faboulous results on ceramic stove tops, and chrome and many other uses. Even removes permanent magic marker. web site will be up soon debrucepolish.com. Phone 612-220-2236.

A small crack, turns into a big crack, Short of ordering a new piece of glass, there is no "fix" sorry. YOu can continue to use it, but eventually it will run across the cook top, and then shatter the glass... Better be safe than sorry.

We followed the instructions that came with the switch that addressed a "compound wiring" configuration. We also used the black jumper wire as shown in the instructions.
We got to this solution in a trial by error manner though, because the three of us working the problem were convinced the stovetop was wired in a "piggyback configuration" and tried that road first. It would have been helpful if the instructions had included an explanation of the switch manufacturer's interpretation of "compound" and "piggyback" configuration.

Hi you are going to have to replace the burner control , this is a easy fix and the thermostat assebley isent that expensive if you give me the info on the unit i will find a part for you Frank

you can replace the top but from what i have seen it cost big buck's , maybe you should look around at used stores that sell ovens and such mite find one in better sshape then yours , I forget how much the top cost but i remember it being expensive

Step 1 Wipe up spills as soon as they happen with a clean dry towel. According to the Jenn-Air website, for glass top cooking surfaces, you should do this even if it is hot since it will be harder to clean up later. Be careful not to get burned.

Step 2 Use a cooktop cleaner once it is cool. You can also use dishwashing detergent and water or just a baking soda paste (made with water).

Step 3 Apply the cleaner to a sponge, cloth or paper towel. For more stubborn stains, you can use a non-abrasive or "scratchless" pad.

Step 4 Rub the soiled areas until clean. Rinse well, especially if you used the baking soda paste as that can leave a residue.

Step 5 Use a razor blade for burned on and crusty stains that will not come off using the previous methods. Jenn-Air states to hold it at a 30-degree angle to carefully remove the stain.

Or you can use this on the link below.

http://www.amazon.com/Blue-Ribbon-88100-Cooktop-Cleaner/dp/B000HM5INA


Good Luck and please rate 4 thumbs up for the free answer

Hi.

If the hood trips the circuit breaker then there is a short. Checking the wires visually is not enough to say that there is no short. Testing is done using a multimeter tool set on impedance (it will read Ohms).

If there is a short between two wires, then the multimeter will read zero impedance (impedance
If the unit trips with fan selector knob in off position, then the short is either at the power cord, at the knob contacts, or because of wiring with heat melting insulation . If possible reach the power cord and test it. The power cord can be tested reading impedance at its plug's prongs. If the prongs read low impedance , then the cord is shorted (zero ohms between two AC plug prongs means that there is contact between wires of different phase). If there is zero Ohms, then there is a short. If the power cord is OK, read starting from the switch side between switch 120VAC and one ground point. If there is low impedance, then the short is back going toward the power socket. Do that until you find the short.

If the unit trips with fan selector on test the knob. Read if there is zero Ohms between knob contacts (usually between its contacts but check also switch contacts). In that case the motor is shorted because of a contact and must be replaced. Other test is done disconnecting and insulating knob contacts and starting the unit. Check also the dual burner switch.

If the unit trips with burner OFF, then the problem is before the switch. Usually power cord or power cord contacts.

Here all parts and diagrams for this unit.

Regards.

Ginko

Hi,

Here is a tip that I wrote to give details about why your cooktop will not spark to light the burners..Cooktop Range Stove spark ignition does not workheatman101

Hi, you may have a short in the line that feeds the electricity to the burners. The oven and the stovetop are probably fed through separate electrical wires. The thermostat may also be faulty or the element is probably bad. Unless you know something about electrical wiring, it might not be wise to attempt to fix it on your own.

Firstly turn the power off. Lift the cooktop out from the benchtop and lean it against the wall. There will be a small panel where the wiring terminates into the cooktop. Remove the panel and disconnect the wiring to the cooktop. Ensure that you insulate all wires properly. You can then turn the power back on if you need to.

Hi,

There are few things that you could try to lighten the spots.

Save With Common Cleaners
Use Baking soda to clean satins from tile, glass,and china; clean inside fridge; remove baked on food from pots and pans.

Cream of tartar.
aAmild acid that can lift stains from sinks and tubs, and remove spots from aluminum cookware.

Lemon Juice
Lightens stains and removes tarnish from brass,copper,bronze and aluminum.

White Vinager
Helps kill germs; removes some carpet stains; cleans coffee makers and chrome.
To clean wood floors, use 1 cup of vinegar per pail of water.

The best way to remove the burn spots is to use a razor blade and scrape it off. However, as you have tried that, follow the above tricks and see, if that helps.I have another option for you. Go to your local grocery store and buy a canister of Barkeepers friend. This is amazing at getting out any kind of stain you may have.Try this as well. It works on couple of occasions for me.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Sorry to read about your problem, I hope this helps you out.

try using an oven cleaner spray... let the range heat up a little..then spray oven cleaner

a new glass top will cost over $600.00 just for the glass.


I have tried to help you. Please help me by vote/rate the response. Thanks If you live in the Denver Area. I can help you out.

Hello, and sorry to read about your problem.
Sounds like you have a general main board failure,or a bad switch
I suggest you call a service company

I tried to help you. Please help me and vote/rate my response thanks.

Look on the model tags and they will tell you for sure but usually cooktop 30 amp Ovan 30 amp and Microwave 15 or 20 amp

F1 Defective touch pad or clock (ERC) Replace touch pad or clock (ERC). Touch pad is a more common problem. Refer to F1 test at the top of this page for more information.