20 Most Recent Jenn-Air JED8430 Electric Cooktop - Page 6 Questions & Answers


The Problem is very
simple. The infinite switch part no 9
Inf switch kit ( Dual )

Part Number: AP4008679
made by WHIRLPOOL which control the element work like a thermostat when the
heating element reach the required temperature should go off and when cool down
to switch on. So the electrical contacts internally the switch has stuck on and
you need to replace the complete infinite switch. We have here below the link
where you can find the infinite switch and also all the other parts diagram of
your model and wiring diagrams which they will help you.



http://www.appliancepartspros.com/partsearch/model.aspx?model_id=47639&diagram_id=28598013#d28598013


Jenn-Air JED8430... | Answered on Dec 28, 2010


I had the same problem... resetting the breaker fixed it for a while but it the problem always represented itself. Replacing the temperature sensor at the rear of the stove finally solved the problem. My problems started after doing a "self clean"

Jenn-Air JED8430... | Answered on Dec 27, 2010


Take off the switch nobs and center grate, then carefuly lift the glass up/ start on one edge first. Have a towel or pillow to rest the glass once off it is around 250$ to replace glass!

Jenn-Air JED8430... | Answered on Dec 22, 2010


sounds like your control card, went defective and blew the power...

Please rate/vote this response, thanks

Jenn-Air JED8430... | Answered on Dec 20, 2010


There was a design change related to this switch. I had the same problem earlier today and figured it out by getting the schematics from searspartsdirect.com. There are two different schematics there (in English). The old schematic is labeled "DIAGRAM NO. 8104P688-60". The new one has five notes in the lower left (that don't help). The key is to split out the red wire coming back from the double burner element. The old way had it connected to "N" along with the RED source power. The new way has it connected to terminal "2" all by itself with the RED source power now connected to terminal "P2". But in addition, you have to add an extra jumper wire that should have come with your new switch that goes from "P1" to "S1". The other connections simply move from the old switch to the new where the locations can be seen on the schematics by referencing the wire colors (example: TAN wire moves from the old "3" to the new "4", etc.). If you are not 100% sure of what you are doing - you shouldn't try this. A wrong wire in the wrong place can short out 240V when you throw the breaker (boom!). Good luck. -- Mark.

Jenn-Air JED8430... | Answered on Dec 17, 2010


Sorry to hear your cook top is cracked. Unfortunately it cannot be properly sealed like a car window. Here is your part#74010843. This is a pretty pricey part and I suggest you use a professional on this repair who will warranty their work in case the glass is cracked again. Furthermore, there are a lot of pieces to take apart and fit back in.
Side note* Be sure to check you owners manual sometimes you can get factory service repaired covered more than just the first year. If the cooktop glass had a bubble or imperfection that could have caused your crack to begin with.
I wish you the very best of luck.
Please rate me if this is helpful to you.

Jenn-Air JED8430... | Answered on Dec 14, 2010


F7 Function key shorted or stuck Replace touch pad or if touch pad is part of the clock, replace the clock (ERC).

Jenn-Air JED8430... | Answered on Nov 04, 2010


For a stove, is that correct? Is the model number of the stove you have the JED8430 and you want to know how to install a fan switch in it, correct?

Please confirm before I help you out here... want to make sure I have it correct.

Just reply to my answer here and I will be right back with you.

Thanks,
Tim

Jenn-Air JED8430... | Answered on Nov 04, 2010


check out
http://www.appliancepartspros.com/partsearch/model.aspx?model_id=47639&diagram_id=681565#d681565

Jenn-Air JED8430... | Answered on Oct 06, 2010


This is usually the infinite switch has failed. They are easy to check and inexpensive. Here is a video that will walk you thru testing an infinite switch. It may be a different model but the testing will be the same. You can also enter your model # for diagrams and illustrations for your specific model. Not all models are available. All parts come with installation instructions.

Jenn-Air JED8430... | Answered on Oct 02, 2010


I didn't have that problem, but I had a burned out switch and cracked cooktop, and found replacement parts at www.appliancepartspros.com. not advertising for them. but I bought they have the parts, it's reasonable cost, and they had it to me in 2 days.

Jenn-Air JED8430... | Answered on Sep 10, 2010


Thanks for your question!

I'm sorry that you haven't received an answer yet.

The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:
1. the question is unclear, incomplete, or poorly worded...
2. the question is mis-categorized - so the correct experts aren't viewing it...
3. the question requires an answer for something that cannot be explained online adequately...
4. specific training, tools, or equipment are required to avoid injury or death...
5. the Experts that are online simply don't have the resources to answer your question fully...

Please feel free to re-work your question if you feel one of these may be the reason.
Of course you are not required - but converting your question to a PAID one usually increases the reply rate as well.

Normal rates for FixYa are...
$ 9.99 answer for one question.
$12.99 Live Real-Time online chat or premium e-mail support.
$29.99 Live Real Time phone support
Sometimes FixYa will run specials for unlimited questions via monthly subscription or reduced rates for limited periods.


Consider the savings that can be had when an informed Expert can save you a $100 service call, or a $350 trip to the car dealership.
Your problem solved - guaranteed! Or your money back!!

If you don't want to pay - feel free to re-submit your question so it returns back to the top of the work queue if you still need help.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question

Jenn-Air JED8430... | Answered on Sep 05, 2010


Hi,


The fuse is located behind the rear panel.You have to replace it
It is called thermal fuse.It will control the display and control of flow of electricity through the board.Yes you are correct blown fuse is the problem that make display will not to work.


It looks like the above picture
9e49940.jpg

You can get the internal wiring diagram in the manual and the parts.part no 34
For more clarification have this:
3f2c3f6.gif

post a comment for further assistance.
thank you for using fixya have a nice day:-)

Jenn-Air JED8430... | Answered on Aug 30, 2010


Hi,
No you will have to run another wire to get 208-240 to the unit... it will not work on 120...

heatman101

Jenn-Air JED8430... | Answered on Aug 30, 2010


Hi,

Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking

heatman101

Jenn-Air JED8430... | Answered on Aug 30, 2010


What you had was a slow short - practically the same thing as in a welder: big and loud flame, localized and the amperage isn't that great. As such it's very possible that the breaker wasn't tripped, especially if you had a big one, over 30Amps.
No, you shouldn't even try to repair it, that unit is dead as a dodo.

Jenn-Air JED8430... | Answered on Aug 24, 2010


Hi,
Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...


Gas Range Repair Burners Keep on Clicking
https://www.fixya.com/support/r4033033-gas_range_repair_burners_keep_clicking

heatman101

Jenn-Air JED8430... | Answered on Aug 19, 2010


Hi


Thanks for using FixYa. If you want a wiring diagram for your Jenn Air JED8430 then please check this link however, if you are looking for something else please post back for further assistance.




Thanks
Rylee





Jenn-Air JED8430... | Answered on Aug 05, 2010


Yes it isa safe to seal the cooktop to the counter with caulk.

Jenn-Air JED8430... | Answered on Jul 28, 2010

Not finding what you are looking for?
Jenn-Air JED8430 Electric Cooktop Logo

356 questions posted

Ask a Question

Usually answered in minutes!

Top Jenn-Air Cooktops Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

MARLON KELLER

Level 2 Expert

111 Answers

Paul Carew

Level 3 Expert

3476 Answers

Are you a Jenn-Air Cooktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Jenn-Air Cooktops

  • Jenn-Air Cooktops

Most Popular Question

broken glass cook top

  • Cooktops
Loading...