20 Most Recent
U-Line Icemaker - Page 3 Questions & Answers
U Line Ice Maker not working at all
if your drain pump is the one you plug your ice maker into and then the pump into the wall plug the pump is full and will not let the ice maker run. must be something wrong with pump
Displays cl
Push one of the keys to see if display is to reset. or turn and off via the display key pad. or unplug the unit for one minute then plug back in if any of these steps return the unit back to operation the unit was probably accidentally entered into a service mode.
Water leaks into storage bin
open the machine control panel side and cube adjustable thermostat available in side,adjusted in the thermostat screw
Why doesn't our new icemaker in a whirlpool ed5 fridge work?
Make sure water line valve is turned on where it taps in to water line,and that ice shut off is down not up, check to see if water is in ice tray or if it is dry if no water or ice is present then water is not getting to it if water tap valve is open then water valve in ice maker is off or ice shut off arm is up instead of down. Try pouring warm water in ice tray see if that will get it started.
Motor & comp. run.every thing cleane. will not get cold. has feron ?
It still could be low on refrigerant. Check suction pressure to see if it is lower than normal. Check the suction line to see if it is WARM - near room temperature. Check the compressor discharge to see if it is hot. check the Condenser to see if it is warm. Check the capillary tubes to see if they are warm. Check the evaporator to see if it is extremely cold near inlet and check the outlet to see if it is room temperature. check the amp draw on the compressor to see if it is to high. if these conditions are present then it is under charged.
Leaks water
I don't know what model you have but if you have the combo unit than check to make sure the drain line for the frig part is not stopped up. if just the ice maker than check the water supply line leaking at solenoid valve inlet side. Tighten or replace fitting, if not there than check water line leaking at solenoid valve outlet side, If so than replace water line and fitting.
U-Line ice maker compressor won't run
Dose compressor fell too hot ? There could be several things wrong. First you will need to get out your Volt meter to make all test. With unit calling for freeze cycle the condenser fan and compressor should be running. Check at the compressor to make sure your getting power to the over load switch and then through it to compressor. if not then check to see if compressor is to hot and has the switch open> If so then unplug unit to let compressor cool down so switch will close. when switch closes plug unit back up and start up unit check to see it compressor starts if so then you will need to see what is causing compressor to over heat. could be dirty condenser, low charge, fan dropping out, Bad compressor.
Model b198 makes one batch then stops
Check the bin arm spring you will have to disassemble the front of the ice maker to do this and check timer motor could be getting hung up. not a cleaning problem. or replace the complete head.
Not finding what you are looking for?