Top 20 Asrock 775i65G Motherboard - Page 5 Questions & Answers

Here's the download link:

DSP Group TrueSpeech Audio Codec 1.1.1.5

http://www.codec-download.com/modules.php?name=Downloads&d_op=viewdownloaddetails&lid=505&ttitle=DSP_Group_TrueSpeech_Audio_Codec_1.1.1.5

1. Extract tssoft32.acm into your C:/Windows/System32 folder, rename your old tssoft32.acm to tssoft32OLD.acm and rename the new unzipped file tssoft32[Codec-Download.de].acm to tssoft32.acm .
2. In Control Panel, go to Add Hardware.
3. Click Next and after it searches choose 'Yes, I have already connected
the hardware'. Click Next.
4. Scroll down to the bottom of the 'Installed harware' list and choose
'Add a new hardware device'. Click Next.
5. Choose 'Install the hardware that I manually select from a list
(Advanced)'. Click Next.
6. Choose ' Sound, video and game controllers' from the 'Common hardware
types' list. Click Next.
7. Click on the 'Have Disk' button.
8. Click 'Browse'
9. Navigate to the 'C:/Windows/System32' folder
10. Choose '$winnt$.inf'. Click Ok.
11. Click 'Continue Anyway' if you get a warning box.
12. Select 'DSP Group TrueSpeech™ Audio CODEC from the list. Click Next.
13. Click Next again to install.
14. Restart if necessary.

*This was taken from another site
It wast posted by Faizi

all fans in time will get louder. The power supply unit has a fan and if you don't already have a fan on the CPU then you can add one to help cool it The fan in the power supply can be upgraded to a quieter one if need be. Any dust on in the case on on the circuit board will retain heat so getting some dry air and cleaning them should be performed. Be sure to ground yourself to the medal case when working with the case open.

You may have a hardware fault.
Try re-seating the hard drive.
Then check the BIOS to see if the hard disk is detected.
If the hard disk is not detected then either the hard disk is faulty or the disk controller on the motherboard is faulty.
To further test the hard disk, remove the hard disk and connect it to an USB hard disk adapter and plug it into a working computer's USB port. If this computer cannot see it as an external hard drive nor can you open the various folders and files, then the hard drive is faulty.
Then you need to replace the faulty hard drive, install Windows on the new hard drive, together with the laptop's device drivers and your programs to get a working laptop again.

SHORT D452 ON MOTHER BOARD WHAT OTHER TRANSISTER CAN USE

Dear Client, unpluged all the data cables, power cables or wires, bios cell and RAMs. Everything should be unpluged from the motherboard for two hours and then reassmbled. It will work properly but when you reassembled it just plug with the follwing devices.

* Power Cables
* Data Cables
* Bios cell
* Processor + Fan
* RAMs

Do not attach CD-Rom or Hard Disk, just turn on the computer without Hard Disk and CD-Rom and try to enter in bios setup. I assure your problem will be solve. Now you can attach the CD-Rom and then try to boot up from the CD-Rom and in the last you should try to attach Hard-Disk. I hope you will do it step by step and get success.


Good Luck

Try to insert the memory in the other slot. Try also a good known memory in the same slot, if it works then most probably that 1GB Memory could be defective. You may also try to rub the gold trims with an eraser for better conductivity.

change the video card should work jim

well you should connect monitor signal cable to the vga out of the nvidia graphix card only then you will get the monitor to work, try it.

Good Luck.

Try Restarting the Windows Audio Service.

Go to Start, then Run, type services.msc, then enter. When the box comes up, look for Windows Audio in one of the subcategories. Double-click it. right click and restart the service. Also make sure it is set to automatic.

which os do you got....
You can try the repair function on the OS installation disc.
Repair mbr

With limited info could be faulty ram / CPU / mobo in that order.

if you are on the system that this motherboard is in, click here and run the advisor. it will make sure all your components are up to par with the requirements of windows 7
Pls RAte This Post

It would appear that you may have an overloading component and the power supply's protection mechanism shuts it off as a safety measure.
The fact that the symptom continues even with another power supply suggests this is the case. However, before running into any conclusions, please check and double check your mb connections.
Also, added high performance hardware has its toll on power. Have you added hardware to your system? If that's the case, try getting a higher powered power supply.
Good luck!

remove the RAM(MEMORY CHIPS) from *********** board and reinsert.if the problem is same replace the chips,get new chips.mostly cleaning the golden lines on the chip with pencil/school rubber solves the problem.
No beep is usually a power problem that can be related to the power supply, motherboard or both. Always check your battery power before thinking there is a bigger problem.
Step3
One beep is a normal POST. That means everything is fine. Two, Three, or Four short beeps are normally about the memory of the machine. If there is a problem with one of your memory chips you should get beeps of different combinations in this area. If you get two or three short beeps, one or both of your memory chips could be in trouble.
Step4
Five beeps point toward motherboard or CPU problems. Make sure your memory and video card are seated properly. Try removing them and putting them back in, only if you are comfortable with computers. Six, seven and eight beeps. Eight beeps indicate problems with your video card. Six or Seven are CPU, or a bad chip on the motherboard. Nine beeps mean the BIOS is bad. Replace the motherboard. Ten beeps means the problem is in the CMOS. All chips need to be replaced.
thanks.

Hello there
try to remove the harddrive and cdrom power cords and cables from them and try to boot and see what happnes if you get power now you will know that one of the 2 are bad or the cords are not fully connected also ty to do the same with the memory stick and also make sure that the cmos battery is good also
please go to this site for more info www.motherboardsrus.net
i believe that your board is shot

This issue only occurs if your RAM(memory card) is not properly placed... Completely shut down the computer first then remove the RAM and place it back properly with locks of both the sides...

?????? Why did this 'Technician' unplug everything?
Was it dangerous...if not get him to plug everything back again.
If dangerous...then dont do it and throw away and buy a new Motherboard

You wont find them at asrock.com because it is not certified for vista.

you can contact them at
http://www.asrock.com/support/TSD.asp
Mark

Can you contact me for support on this motherboard. Motherboard most likely blown, contact me on my support pages on http://www.motherboardsrus.net Click on the ?emachine support page? link use the email contact us button for more help. Chris, the computer doctor. 07926-106150

pls see the link for drivers and Pls rate me FIXYA for help

http://www.asrock.com/mb/download.asp?Model=775I65G&s=775