20 Most Recent ASUS P5PE-VM Motherboard - Page 7 Questions & Answers

pls check ide cable/SATA cable and change power pin

The Asus P5PE-VM mainboard uses the Marvell 88E8001 GB LAN controller.
You can download the LAN driver HERE.

Is this on an existing system or a new build ? Either way it sounds like a bios issue , sometimes you need to get into the bios when they act up and reset it to factory default. You access the bios by pressing a key such as f2 when you start up the PC. then check to make sure your hard drive is listed in the hard drive portion of the bios menu. If it is not listed it could indicate a loose cable or a failed hard drive. When exiting the bios be sure you save changes on exit. One more option is to restore factory defaults - then save changes and exit.

Good luck,

Don F

Hi, the mainboard does not support windows 7.
The link is here:

http://support.asus.com/Download.aspx?SLanguage=en&m=P5PE-VM&p=1&s=22

But you can try the vista driver it will probably work.
Or select the compatible mode when you install the driver.
Select the operating system 32 or 64 bit.
Select the driver you want and click on global for download.
And unzip the file before installation.

You must have at least 2 gigabytes of ram if you planing to
run windows 7.

You just need to update your motherboards sound driver. Try to download it from your motherboards website, or get driver installer software that would search the internet automatically and downloads the driver that *********** board needs to be able to work properly. If you have your motherboard installation disk with you reinstall the drivers all of them and then try to listen if sound is audible once more.

Hi, the download site is here:

http://support.asus.com/Download.aspx?SLanguage=en&m=P5PE-VM&p=1&s=22

There is no drivers for windows 7.
But sometimes the vista drivers will work.

Get your driver to this link.http://support.asus.com/download.aspx?SLanguage=en&p=1&m=P5PE-VM&hashedid=k3h0ZFVu9Lo1dUvkHope it helps thanks

check your cooling system and make sure it is clean

Any brand inexpensive PCI sound card will be adequate. Remember to first enter the MB bios and disable the onboard audio first. You will now only be able to connect to autio ports from the back... front will no longer work.

Hi,
Welcome to fixya. If the computer is still booting to windows and can access the internet,you just have to download the 6006 repair tool and here is the link
Download Error 6006 Repair Tool.

If it did not resolve the issue or your computer wont be able to boot to windows normally or cant access the internet anymore,you have to contact ASUS for a repair technician.

Hope this helps.:)

You can download the audio and device drivers from ASUS WEB site.Select your model motherboard/computer/laptop, and make sure you select driversthat matches your Windows operating system. Please click on this link to theirWEB support site : - http://support.asus.com/download/download.aspx?SLanguage=en-us

Hi, you can download a manual and drivers here:

http://www.asus.com/Motherboards/Intel_Socket_775/P5PEVM/#download

Please select your operating system.
Download the asus update utility and upgrade the bios
its the easyest way to do that.
Unzip the file before you install it.

You can also reset the bios to factory settings.
Look in the manual how you do that and for troubleshooting also.

Hello,

I understand your request for drivers for your Asus mainboard model, P5PE-VM.

Please copy and paste the link below into your browser to go to the Asus support page for your model mainboard. The page will show available downloads, including manuals, and drivers.

Follow the prompts for infomation that may be requested, such as your operating syste, XP, Vista or Wondows 7.

Good Luck








http://www.asus.com/Motherboards/Intel_Socket_775/P5PEVM/

That may be in the bios, a lot of options in bios will allow you do turn items off, like WIFI or onboard video, etc. You chould be able to get the users manual on the ASUS website. that will give you more information.

Test all leads that attach to your hard drive including electrical extensions,IDE,SATA

the leads from your "((MOTHERBOARD TO YOUR HARD DRIVE))" make sure they have a secure connection and are not faulty or just replace them they could be faulty make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty even the electrical extensions or just replace them they could be faulty a computer needs its connections to continue its cycle and have an end so any faulty leads will end up with a computer error even something as small as a faulty electrical extension or fan lead can cause a computer to shutdown

computers need all of the data and electrical current to travel through every working device and to have an end to be able work properly

a motherboard and a hard drive any leads between them will fail before your motherboard or your hard drive if its a flat ribbon 40 pin type IDE replace it this will be the first to fail check all electrical power input and extensions make sure they are securely seated even the cd/dvd floppy drives need to have current go through make sure these drives are working

also check the Cmos battery and computer ram make sure they are securely seated with no dust built up or in the sockets

and you might not have enough RAM random access memory not having enough will cause your computer to run over its maximum limits and can cause the blue screen of death and hang also uninstall some unnecessary programs and run the chkdsk utitlity control panel administrive tools,computer management ,disk management right click on your drive select properties click tools you should see click check now click start two boxes automatically fix files and scan for and attempt recovery of bad sectors place then a tick in both boxes then select check now,start should schedule this task when restart

you should have no input while the chkdsk utility is I progress any input might damage your computer

then defragment your hard drive scroll to the bottom toolbar (bottom of screen) right click you can select task manager applications also processes you will see whats running on your computer you might have virus slowing your computer also select users you will see who is using your computer download and run a registry cleaner cc cleaner is 100%free http://download.cnet.com/ccleaner/

if you need any more help with this post a replyhope this helps you

check leads from motherboard to hard drive make sure connections are secure Ide/Sata include electrical also check your graphics card make sure its seated properly with no dust built up or in the socket if you remove the card restart your computer then reinstall it this should activate the found new harware wizard
hope this helps you

test all leads that attach to your hard drive including electrical extensions,IDE,SATA

the leads from your ((motherboard to your hard drive)) make sure they have a secure connection and are not faulty or just replace them they could be faulty make sure all leads that are attached to your drives dvd\cd have secure connections and are not faulty or just replace them they could be faulty ?

even something as small as an electrical extension or a faulty fan lead can cause this problem computer needs all of the data and power to travel through every working device and to have an end for a computer to be able work properly

a motherboard and a hard drive any leads between them will fail before your motherboard or your hard drive check all electrical extensions make sure they are securely seated even the cd/dvd drives need to have current go through make sure these devices are working

could be a dirty graphics card you might have remove the graphics card and clean the socket hope this helps you

When you open up your PC does it have a beep sound continuously.. if it has try this steps make sure you turn off and unplug your pc power chord before doing this 1. check your memory card and graphic card by disconnecting it in your motherboard..after doing it 2. Clean it using pencil eraser the bronze plated part of your video card and memory card you connect to your motherboard rub it with pencil eraser in a single stroke vertically..After doing it connect it again to your motherboard the video card and memory card then turn on again your pc. If the beep stops and this solved your problem good. But if not try to re install your operating system...Hope it will help you..

Hey, voc? pode baixar um manual aqui com asus:

http://www.asus.com/Motherboards/Intel_Socket_775/P5PEVM/#download

Primeiro, selecione seu sistema operacional.
Selecione Manual e clique em global para download.
Descompacte o arquivo antes que voc? possa l?-lo.

Voc? pode remover a bateria da placa-m?e por 10 minutos
Isso ir? redefinir bios as configura??es de f?brica.

what is your board problem define it
email id= [email protected]