20 Most Recent
Whirlpool GEW9200L Electric Dryer - Page 2 Questions & Answers
Too long to dry
When you say too long I assume the dryer does heat simple trick disconnect exhaust tube from dryer at bottom run a cycle room will get hot if dryer drys correctly then you have a restriction in the exhaust, dryer has to be able to breath just like a muffler on a car a restriction will cause the heat circuit of the dryer to cycle on/off on the hi limit instead of the cycling thermistor which will give you a long dry time hope this helps
3/23/2014 3:02:39 PM •
Whirlpool...
•
Answered
on Mar 23, 2014
Dryer will not heat
Door switch could be opened. Heat element must ohm out for continuity. Also check the overload sensor switch in it rear
11/10/2013 4:14:40 AM •
Whirlpool...
•
Answered
on Nov 10, 2013
Gew9200lwo. Heating element won't light up.
If you've ruled out a loose connection either before or after the element then work backwards. It sounds like there's a switch that isn't closing but don't rule out a bad connection somewhere in the circuit or a problem with the timer.
10/29/2013 8:55:27 PM •
Whirlpool...
•
Answered
on Oct 29, 2013
Dryer will not heat
The problem with your dryer is bad coils on the gas valve. Replace the coils, Part number: AP2150379 and the dryer should be back to normal.
To get access to the coils you have to remove the front panel.
Good luck.
6/15/2013 3:37:39 PM •
Whirlpool...
•
Answered
on Jun 15, 2013
My whilrpool duet dryness lights and it will not dry
One or both. Several factors here. First turn off the breakers and then back on. That settles the fuse issue. Next check the wiring at the terminal block located in the back of the dryer. Look for burned or frayed wires. Next check the element for a break or weak spot. Next check the relay which is under the top. Tie the 2wiresvtogether and see if it works then . If it does, then replace and you are back in business. If this does not work, let me know and we will go another route.
3/12/2013 2:39:00 AM •
Whirlpool...
•
Answered
on Mar 12, 2013
Drum turns, but get no heat
replace the glo bar that lights the gas and make sure the vent in back is all clear to the outside of the house
1/16/2013 12:08:33 AM •
Whirlpool...
•
Answered
on Jan 16, 2013
Not finding what you are looking for?