20 Most Recent Amana ACD106R Wall/Window Air Conditioner - Page 2 Questions & Answers


There should be a fan symbol on your remote control. In the "mode" control, there should be the following options.. Heat, cool, Auto and fan. If you select fan, only the fan will run. No heating or cooling.

Amana Heating &... | Answered on Jun 10, 2019


Check voltage in , there could be one side of breaker burned causing only one side to come through. This happens on older main breakers frequently which messes up whole house.

Amana Heating &... | Answered on Jun 10, 2019


How are you determining that one section.is cold and one warm? If this is in fact the case you have a blockage in the coil or a compressor that is down provided this is a multi compressor unit.

Amana Heating &... | Answered on Feb 06, 2019


I'm leaning 2 directions, one is that your tstat is sensing your heatpump can not keep up with the load. Therefore bringing on heat strips or two, you have a cycles per hour limit set for compressor heating and your machine is cycling too often.

Amana Heating &... | Answered on Jan 27, 2019


F1 - Control Board Failure - Replace control board (ERC). F2 - Oven Temperature Too Hot - Replace oven temperature sensor. F3 / F4 - Shorted or Open OvenTemperature Sensor - Replace oven temperature sensor. F5 / F6 / F8 - Control Board Failure - Replace control board.

Amana Heating &... | Answered on Jan 20, 2019


Clean the filter and try it again

Amana Heating &... | Answered on Dec 31, 2018


I would guess two possible problems - dirty thermostat contacts and many appliances are also fitted with a thermal fuse or other type of thermal cutout which might have failed.

Amana Heating &... | Answered on Dec 13, 2018


How much power is the question. Remember, heating coils usually require 240 volts. You likely are only getting 115 due to a faulty limit switch. 115 will carry through to the other side of the switch from the coil side leading you to believe the switch is good. Remove both sides of switch and test continuity.

Amana Heating &... | Answered on Dec 12, 2018


Motor might be bad and shutting down on thermal protection. Is this a direct drive or belt driven ? .if belt driven try adjusting the belt tension or just replaced the motor

Amana Heating &... | Answered on Dec 11, 2018

Not finding what you are looking for?
Amana ACD106R Wall/Window Air Conditioner Logo

23 questions posted

Ask a Question

Usually answered in minutes!

Top Amana Heating & Cooling Experts

Donni Steen

Level 3 Expert

687 Answers

Bill Long

Level 3 Expert

606 Answers

WatsHVAC

Level 1 Expert

35 Answers

Are you an Amana Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Amana Heating & Cooling

  • Amana Heating & Cooling

Most Popular Question

when turn window

  • Heating & Cooling
Loading...