20 Most Recent ASUS M2N-MX Motherboard - Page 8 Questions & Answers

the asus site is abit quirky but the place to find the drivers for that board are here http://www.asus.com/product.aspx?P_ID=0pKBwEIE8tqMT4j7
chose the operating system you are using and it will take you to the correct drivers. there is an se and se plus board as well so perhaps have another look just to be sure, that's very important if you wish to upgrade the bios as well.

the beeps are post during post the very first work is done by the ram,all the memory in the ram is first transferred to the hard disk,and remains active untill turned off. the grrr is the sound its not getting enough power test your PSU power supply unit or replace it if the fan is not working the PSU is faulty One bad/faulty lead can cause a computer with lots of problems replace all the leads that attach to your hard drive including electrical extensions + IDE,SATA the ones that attach from your ((motherboard to hard drive)) make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty or just replace them they are probably old and faulty ? hope this helps

Into the green analog audio port.

To reset the BIOS password read the information from this link.

Try installing the latest audio driver.
You can download the drivers from ASUS WEB site. Selectyour model motherboard/computer/laptop, and make sure you select the Windows XPor Vista version of the drivers that matches your Windows operating system.Please click on this link to their WEB support site : - http://support.asus.com/download/download.aspx?SLanguage=en-us

to trouble shoot motherboard you need to know basic of motherboard there are mainly three thing s for motherboard to work first voltage +12v +5v +3.3v the motherboard then needs clock and reset to start adreesing the lcok is produced by the 14.318Mhz crystel and restet is produced by 32 khz crystel when the power is on first the clock has to be present for the reset to function if the clock and reset and there and the adress line is not still working means the elecrolitic capcitors are fult the capacitors in motherboard have huge role to play they are ones prvent audiolines entering the adress lines

CMOS Checksum Error, which refers to corrupted values of the CMOS settings, the ones you set through the BIOS setup program. This error means the contents of the BIOS code itself are damaged.
Diagnosis: The BIOS ROM chip on the motherboard is probably faulty. It could also be another component on the motherboard.

You should make sure that all of the BIOS settings in the system are correct, by rebooting the system, going into BIOS setup and double-checking all the values (hopefully against a recent

you should select the option for optimised defaults select that one You will also need to reset the time and date. Save, Exit and re-boot and everything should then work.

to enter bios you will see on the bottom of your screen during the boot up process to press a certain key press and hold that key enter bios scroll to advanced bios features hope this helps

if you have replaced *********** board to up grade it you will need to reinstall windows for the drivers for that mother board.

Go to this site and download the drivers you need for the motherboard

if you are not able to install the drivers let me know


http://usa.asus.com/product.aspx?P_ID=0pKBwEIE8tqMT4j7&content=download

service centre of asus in vijayawadaare;

Rashi Peripherals Pvt.Ltd. Vijaywada Product- LCD, VGA, MB, Notebook, EeeFamily , ODD
D.No.46-19-14, 1St Flr.,Mandavaripet,
Dondaparthy,Vishkhapatnam - 530 016
Tel No.0866-2488373
[email protected]

Neoteric Infomatique LTD,Vijaywada Product- LCD, Notebook, EeeFamily
28-19-32 Jarda Street,Arundel Pet,
Near Rama Mandiram,
Eluru Road --520002, Andhra Pradesh

Tel No.0806-6664563
[email protected]

or you can visit this page

down

Hello Omni,

Try using the vista drivers at support.asus.com. sometimes xp drivers will work in windows 7 too. They may not be the latest and greatest drivers, but it will get your hardware working.

Hope this helps!

Regards,

Joe

make sure you have installed internet explorer , and plugins like adobe , and real tech driver for Ethernet , the connect it to the modem , before that you have to configure your modem too,,, according to the service that you are using with right IP address. now restart and use it.. this should work..
thanks for rating Good luck

if this drive is not showing in my computer
you might have to physically unplug the leads for this cd rom then plug them back in this will activate found new hardware wizard
hope this helps or
you might have to uninstall then reinstall your cd rom or uninstall the driver then reinstall for this device
if this does not fix the problem it might be a registry problem if you cant see your disk drive in windows explorer
Close all open programs
Click on Start, Run, and type regedit and press Enter
Click on the plus signs (+) next to the following folders
HKEY_LOCAL_MACHINE
SYSTEM
CurrentControlSet
Control
Class
{4D36E965-E325-11CE-BFC1-08002BE10318}
This folder is the DVD/CD-ROM Drive Class Description in the registry. Look for any of the following names in the right hand column.
Upper Filters
Lower Filters
Upper Filters.bak
Lower Filters.bak
If any of the above keys shown in step 4 are listed, right-click on them and choose Delete
After deleting the keys, close the registry editor
Reboot your computer
Open My Computer and check to see if your CD or DVD drives have returned. You may also want to open Device Manager and verify that the yellow exclamation and error code on the CD or DVD drive is gone.

hope this helps

hi shreyash, do you having on board audio card mean go to bios and check weather you have disable , if it was disable mean enable it.

If you using internal or external sound card mean, go to bios Disable your onboard audio card , so only your internal or external sound card will work.

And i will give original Asus mn2 motherboard driver , install it and check it once. copy and paste the link i have given below

http://www.asus.com/product.aspx?P_ID=0pKBwEIE8tqMT4j7

or click here

After page get loaded scroll down, click download in tab and select your OS and download your Drivers.

Good luck

Try downloading your driver from the link:

http://support.asus.com/download/download.aspx?SLanguage=en-us&model=M2N-MX%20SE%20PLUS&product=1

Hello and thank you for allowing me to help you.

PLEASE reward the ACCEPTED best answer

******There are several ways to configure your setup, we will cover the most cost efficient way first****

1. You can purchase a TV TUNER PCI CARD or AVG GREEN OR BLACK PORT (SHORTER) to plug straight into your WHITE COLOR slot
2. All you would need is a TV COAXIAL cable to plug straight into the available coaxial cable slot AFTER installing the software
3. You will know that your install went well when you do not receive any errors
4. You will more than likely receive a remote control with your new card

More expensive method

1. Purchase a USB BASED TV TUNER with an available coaxial cable port to plug your cable tv line straight in. This should also include a remote.

Please do not forget to award your ACCEPTED ANSWER

THANK YOU AND PLEASE RETURN WITH MORE QUESTION/RESPONSE REQUESTS

if you unable to hear sound, the best way to overcome this problem is to re-install driver it. the link provided below will take you to the place from where you can get it downloaded.

http://drivers.freesoftz.com/sound-card

Test your PSU or replace it if your power supply units fan is not working your PSU is faulty

One bad lead can cause a computer to fail to detect a hard drive continue on a cycle or to shutdown

Test all leads that attach to your hard drive including electrical extensions,IDE,SATA and

the leads from your motherboard to your hard drive make sure they have a secure connection and are not faulty or just replace them there probably old and faulty make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty or just replace them they are probably old and faulty ? hope this helps

You can download the drivers from ASUS WEB site. Selectyour model motherboard/computer/laptop, and make sure you select the Windows XPor Vista version of the drivers that matches your Windows operating system.Please click on this link to their WEB support site : - http://support.asus.com/download/download.aspx?SLanguage=en-us