20 Most Recent Whirlpool GU2400XTP Built-in Dishwasher - Page 3 Questions & Answers

The main board sends power to the display lights. Check with a multimeter for voltage coming out of the main board to the display board. If no voltage the main board is bad or the fuse is bad.

You start by describing the exact problem you're having. Your question is like "How do I fix my car?" You go to college or a trade school for 2 or more years to learn how to fix your _________ (fill in the blank). If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

No, it's not normal for them to be soaking wet at the end of the cycle, but there are things that can affect this. First, make sure you have Heated Dry selected. Next, make sure you are using rinse-aid (Jet Dry), because the new dishwashers don't use as much heat as the older dishwashers, and Jet Dry will greatly aid in the drying. Be aware that plastics won't get dry in any dishwasher. Other things you can do is turn on the extra heat options in the wash cycle, and turn on the Sani-Rinse option (if you DW has such options). Otherwise, you may have a heater or controller problem. If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Try throw the breaker off for 15 min then back on. That may clear the program. If not restart it on the "wrong" cycle and let it finish out.

Whirlpool dishwashers use a wax motor or a solinoid to release the door at a specific time during the cycle. So for proper cleaning the soap cup is nessesary . The part isn't that expensive and fairly simple repair.

there should be a white type screw that goes in the middle and scews into the middle

Replacement parts for this type of dishwasher can be found on amazon. here: Amazon com Whirlpool Gold quiet partner III parts (You can ask sellers for particular problem, they know the best.) I hope this was helpful. Cheers

I held down the heated dry button & it worked!

Check the power supply. Check the fuse located on the control panel

hi you can if they made that model in stainless steel

At least five years.

remove front lower panel below door. paper with spec's and diagnostic procedures and codes should be there. is water on? cause water valve can buzz if water no turned on under sink.

check carefully around the locking lever assys., both on the door and on the unit itself; looking for bent/cracked/damaged/obstructed housing or possible safety switch on assy. defective.