Top 20
Acer AL2671W 26 in. LCD Television Questions & Answers
Scan doesn't work on Acer AL2671W
Main system control memory IC fault. This is a very small IC; have 8 solder terminals, and can be located very near to the main system control-chroma IC. Check and replace it. Be sure to replace it with the same number printed on it; in all respect. Otherwise, it won't go.
http://electronicshelponline.blogspot.com/ Before replacing it, try a reset to this set, and then check.
There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; check the site linked here.
Moje lcd jen sviti orazova kontrolka pover co stim
If you're sound in electronic, and wish to get more details,
check this link.
http://electronicshelponline.blogspot.com/ Selecting the view option, either to
Mosaic
/ Time slide, can be selected by the
drop-down list, at the top left
of the display window, will make surf easy. You can also do a search, by type in the brand name/model
number/IC used, in the search box at the top right of the display window.
No power on tv
Check its main power regulator board. It might need replacement. If you are not familiar with
electronics, do not attempt to repair.
Whether you suffer fatal electric
shock. Instead, contact
any experienced service technician, or the nearest service center.
Acer AL2671W wont turn on
Sounds like a problem with the power supply board, typically power surges will cause fuses and capacitors to blow. If you go to tvrepairkits .com you can find a power supply kit with instructions that will allow you to repair this problem yourself. They also have coiled solder which works really well...hope this helps.
I have an AL2671W26 Acer
I have an AL2671W26 Acer Tvwhen I turn it on everything is fine for about 30 seconds, then I loose the picture, but the sound it there.Any thing I can try would be greatly appreciated.Thanks. i am also searching same fault in my lcd
I have an Acer AL2671W
Hi Oliver,
This is an indication of out-of-regulation in the power supply section. This was caused by leaky/dried electrolytic capacitor in
that section. It will drop the supply from normal voltage and
will disable the unit.It needs a little warm-up to make itself stable but the
symptom will get worst. Sometimes it has a bulged/dome at the top but not all, it is better
that you have a capacitor
checker/tester to determine
its condition. Your unit will back to normal again if the leaky capacitor is
isolated.
If you don't have necessary tools
and test instruments, and can't do the job yourself, I would advice you to
look for a professional to troubleshoot the problem. Don't
attempt to work in the power supply if you don't know the safety precaution of handling it, there some stored
electricity enough to hurt you with a little mistake only.
Also check if your unit is under warranty /extended warranty,
avail it because the manufacturer of your unit will fix it for free. Don't open
the back panel, this will void the warranty.
Hope I helped you.
Have a nice day!
Thanks for using Fixya.
Always on standby i have
Look for swollen capacitors on the power supply board. Replace by removing and soldering in new ones.
Please leave feedback
I have a AL2671W 32
there is a good website called www.shopjimmy.com that has spares for nearly every make and model of tv that should be your best bet if not keep your eye out on ebay many people sell parts of broken up tvs but there usually not garanteed
Not finding what you are looking for?