20 Most Recent
Whirlpool Calypso GVW9959K Top Load Washer - Page 6 Questions & Answers
Kenmore elite calypso washer
CE
Here is a
link for the error codes on calypso, in most cases it is a blown fuse on the motor control board so I would first check that. Hope this is helpful and please remember to rate this solution.
8/15/2013 6:59:32 AM •
Whirlpool...
•
Answered
on Aug 15, 2013
ERROR 44
on opening my yahoo mail page in inbox list of messages are there but when i try to read i get message sorry temporory error 44
5/4/2013 6:23:31 AM •
Whirlpool...
•
Answered
on May 04, 2013
The washer stops working and the light flashes L5
The control should flash this error code if it cannot detect the lid switch opening and closing properly.
This error code may also be used if there is a disagreement between the motor and machine controllers on the state of the lid switch.
The control should not allow the unit to run in this condition. This code will also appear if the user presses the START key while the lid is open.
Open the lid or press STOP/CANCEL to clear the display
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question!!!!!
4/3/2013 11:58:52 PM •
Whirlpool...
•
Answered
on Apr 03, 2013
Gets stuck on spin
It is
possible that the machine does not start off the cycle because there are errors
due to feedback from the inputs. For the program to start up the main program
controller must initiate the INLET/MOTOR/DRAIN
pump/ valve to open up and allow each function to be driven starting from
the flow of water into the drum as also the drain valve to open to exit the
water at the point of the program cycle. If this does not happen then the
voltage at the valve/motor/pump must be checked or the fault relates to no
voltage from the controller. This means
the controller is a suspect.
2/12/2013 11:47:33 AM •
Whirlpool...
•
Answered
on Feb 12, 2013
Calypso washer won't drain
It sounds like you may have something stuck in the pump...try and locate the pump(normaly at the bottom of machine)and unscrew the cover...be aware that the machine may still have water in it....once you unscrew the cover,have a look and a feel inside...there may be a coin or other object stoppint the pump from turning...remove any foreighn object...replace the screw on cover and try to drain the water again....this should solve your problem.
1/17/2013 5:04:04 PM •
Whirlpool...
•
Answered
on Jan 17, 2013
Not finding what you are looking for?