20 Most Recent Whirlpool Calypso GVW9959K Top Load Washer - Page 3 Questions & Answers

The problem is not the pump. IT appears that the water control valve is bad or the voltage that controls it is changing and then the valve stops working.

Hello James; My name is Peter. I am a retired field service appliance technician. On the bottom of the dome are 4 clips that you must push in on. Be careful not to damage the seal ring.

It's hard to tell by your description of the problem, but it sounds like it could be the timer If it's not running while in spin mode, or as simple as a belt if it's running and not spinning fast enough.

Your LiD sensor might not be working.

8272124 that's part number for lid switch. Amazon I'm sure has it.as far as schematic . There's one taped to inside front of cabinet. Or visit whirlpool.com under customer service heading is a link to manuals

there would be a wire diagram , which should include a schematic of the board and check points either within the console, or i believe on this unit its located in a clear plastice bag glued to the inside of the front panel, tip the machine back you sould be able to reach up and remove it that way

It will be some where, try google, try espares.co.uk they are good for things like that, use them a lot.

Call the manufacturer or get a multimeter to check things manually

Check bottom drain hose under neath the washer

Go to their site, it will tell you.

www.docyue.com/nupdf/maytag-calypso-washer-error-codes.pdf

A CI is an to high amp draw on the motor. In my experience it could mean your motor is bad, or motor control board is at issue. The only way to really check is to have an amp meter to see if the motor is drawing to many amps. 285917 MOTOR ABOUT $250 8571359 CONTROL BOARD ABOUT $200. The biggest issue, is you may also have a transmission locking up, basket drive issues, bearing issues, etc causing the motor to pull the high amps.