Top 20 Lucent PARTNER18 Corded Phone Questions & Answers

No such password 3exists.

This should solve your problem https://www.youtube.com/watch?v=XWlFtwTCtqU

It prob in DND mode - if this is right phone http://www.beatriceco.com/bti/porticus/bell/pdf/bsp/518457701_avaya_how_to_use_your_partner_phone.pdf

Use Liquid Paper or any other correction fluid.

Have you tried this ...In ASA, enter the command ch sta xxxx.Select tab 2In the second column of features , you will see "Auto Answer". This should be set to "none".Good Luck!

The caller ID information is sent between the first and second rings, so there's no way the receiving phone can display this data on the first ring. You have to wait for the second ring (or just before it).

you must have to read your instr. manual for to exchange the ID.go to section operation , and fix it.God bless you

What happens when you dial 777 on the intercom? If you get Partner mail, then it's a start. Now you just need to find out which one and the admin password. Normally it's 99 for admin access and the password is defaulted to 4321. I'd be searching the internet for a manual.Carl

You cannot transfer an INTERCOM call.

switch it off. if it uses a battery, remove the battery and then switch it on again

How do I change the names that are asigned to certain extenions??

A tall order, but here's a start http://www.wedophones.com/Manuals/AT&T/PARTNER%20ACS%20R6-0%20Installation%20Programming%20and%20Use.pdfCarl

that is based on the network you use. The will be a number provided by your network provider you can call to change it. I will advice you call the customer care of the network you use for that number. Or which network?

If the Comcast people changed the equipment in the phone room they probably ran direct lines to each phone or put filters in the lines. The reason you're not seeing the lines light up is the phones are not wired correctly now. The cable box that all of your lines are coming from must have a 1 to multiple line adaptor for each line. The adaptor feeds all of the phones. Communication for the intercom and the line in use lights goes down the phone lines so ther has to be a direct connection between all of the phones. If there are filters in the lines they must be put between the cable box and the line splitter. You can get the line splitters at Radio Shack (Model 279-435 for 1 to 3 adaptor).

Sounds like the line 3 button on that set is programmed as something else. When you press feature 00 and the line 3 button what does the programming say on the screen?

Call in a pro. it sounds like you lost all your programming with that power outage.
Depending on your processor type, you may have to re-program teh entire system, or just restore a backup....

you can contact the mobile service provider........

www.mbl.edu/it/telephone_servies/pdf/8400.pdf

Please rate 10 if this helps.

Which ones? System speed is programmed from station 10 or 11 and goes in the 6xx's, depending on your version of software. The start is FEATURE 00 FEAT 6xx and dial the number You can continue programming more numbers by pressing FEAT 6xx or Feat 00 to exit.

Personal speed dial numbers are programmed similarly, except they are in locations 80-99 on each phone and can be programmed from the phone if it's a system phone.

Auto Dial buttons use blank buttons on your set. Feature 00 pressing the button and dialing the outside number store those. Again, Feature another button will let you program another button, or Feature 00 ends programming.

Carl

Is there a question here? If the display is blank, swap a known working phone into its place or move the blank display phone into another location. It's either a bad phone, or bad wiring.

Carl