20 Most Recent
Whirlpool RBD305PD Electric Double Oven - Page 4 Questions & Answers
Rbd275pdb12
Control Panel has likely failed (circuit board). You can try removing the power wire from the back of the panel and then replug it back in to see if it resets the board, but Im sorry to say your likely going to have to remove and replace the control panel.
12/2/2013 11:01:46 PM •
Whirlpool...
•
Answered
on Dec 02, 2013
Upper oven locked and control panel is not working
First off this oven sucks. Now to fix the problem replace the Fuse assembly with #4451042 an $11.00 part. SHUT OFF THE POWER AT THE BRAKER PANEL FIRST. Then open the lower oven door and remove the two small screws that hold the side trim pieces, slide them up a bit to remove. At the top of the track remove two more small screws that hold the display panel in-place and lift the cover up and away from the oven. The fuse is inside of a clear plastic tube with a female spade connector at each end of it. replace the failed part and put things back the way that they came off. Next time don't by a Whirlpool.
12/2/2013 12:50:47 AM •
Whirlpool...
•
Answered
on Dec 02, 2013
F2 E6 Codes appear, time flashes off and on
HI, this is a faulty key pad issue. check the following.
1. Check keypad connector for firm connection (keypad connects to control
board).
2. Press CANCEL. If error code returns after 60 seconds, replace keypad
(also called touch pad or membrane switch). Some models incorporate keypad
in to control board as one unit. In this case, replace control board (also
called ERC or clock).
11/29/2013 10:54:07 PM •
Whirlpool...
•
Answered
on Nov 29, 2013
Rbd305pd light
door switch/spring is defective or clogged with grease.
11/23/2013 3:26:57 AM •
Whirlpool...
•
Answered
on Nov 23, 2013
Display is black
I had a very similar problem (I was observing the error & fault code "E6 F2", but not always. I did always have the beeps.) on a Whirlpool RBD305PDS14 double oven built-in. I spent time today (Oct. 21) and traced the problem down to the keypad flexible cable that connects the keypad to the oven control panel.
[ALWAYS WORK WITH POWER OFF!!!]
I cleaned the flexible cable contacts that seat into the board mounted female connector on the control panel board using a Q tip and isoproply alcohol. This did the trick.
(Elsewhere in this forum, there is information on how to remove the oven control panel and gain access to the control assembly. I posted this information - keywords in subject: Whirlpool RBD305PDS14.)
11/16/2013 9:41:47 PM •
Whirlpool...
•
Answered
on Nov 16, 2013
Not finding what you are looking for?