20 Most Recent Whirlpool RF378 Electric Kitchen Range - Page 9 Questions & Answers

Check that the power at the circuit board is working. If you have a 220 VAC line, only one side of the line may be powering the oven. In many cases the fuse box has a Dual Circuit breaker whereby one side may be tripped or defective.

indicates a failed thermostat in the oven switch if the electrician finds that to be so , the fix is a replacement switch

Try to depress and hold the oven light (the little light bulb symbol) for 3 seconds. The green light on the Cooktop Loockout flashes and turns off

Well, I have seen a lot of issue with this type of ovens. How old is your apparatus? If the wires on the back look corrode or some how burn up that means that there were an over heating at one time or many times. Overheating on wires means excessive voltage going trough or been drown from. The wires get hot transferring too much voltage to the internal circuits thus putting stress on the components. The clock/timer got damage by this concurrence thus affecting part of the system of your Oven. If you change or clean the wires just check the whole machine, use your senses( eyes, smell) to look for the obvious that way you will save time and money.

F9 or F9 E0 Possible Solutions

Reset power to the product:

This code will most often indicate that the appliance is wired incorrectly at the home electrical supply, or at the hard wire connection.

• If your oven was installed recently (within approximately 3 months), contact a qualified electrician to verify the electrical supply.

During a power outage, if there was an unexpected amount of power supply line "noise" that the control detected as an incorrect voltage amount, the control could display the F9, F9 E0 or PF Error Code. Also, if any keys were pressed before the 10 second delay interval on power up, this could cause the F9, F9 E0 or PF to appear.

• Power unit down by turning off the circuit breaker(s) for one (1) minute.
• Power unit up by turning on the circuit breaker(s).
• Monitor the oven for one (1) minute to ensure the error code does not display again.
• Verify oven operation.

Still need help? Call or schedule service.

You may need assistance from a qualified technician. Call 1-866-698-2538 or click below to schedule an appointment. Schedule Service Online

Barbara, Not to be insulting but did you lock the oven door? If not, it will beep and stop. I hope that is it. Semper Fi, Z

see if this video helps- https://www.youtube.com/watch?v=vzlLHJiy5KE

Whirlpool RS675PXBQ2 wiring diagram link below. http://www.appliancepartspros.com/parts-for-whirlpool-rs675pxbq2.html Hope this help :-) I’m happy to assist further over the phone at https://www.6ya.com/expert/latoya_8ed1bf3dc615c15d

We'll be glad to assist you with the age of your Range. In order to do so, we'll need the serial number. Please email us at [email protected] at your earliest convenience with the website you reached out to us on (fixya), brief description of your concern, your name, address, a phone number and best time to reach you along with your model and serial number.

its probably your clock control Go to repairclinic.com it will help

Are both of your heating elements lighting up when you are preheating? It sounds like the oven thinks it is pumping power into both elements and one isn't working. Oven elements are generally easy to remove and replace!

call in a gas fitter to ensure that the right size jets are in use for the gas in use have the regulator tested and reset