20 Most Recent
Whirlpool Gold White-on-White 21.9 cu. ft. Conquest Side-By-Side Refrigerator with Ice and Water GD2SHAXLQ Side by Side Refrigerator - Page 2 Questions & Answers
WHIRLPOOL REFRIGERATOR
my refrigerator gold is running but not cooling I have the model number and serial numbers if that is helpful please help
Filter for the water dispenser
LOOK AT THE TOE PLATE BELOW THE DOORS. THERE SHOULD BE A ROUND DIAL UNDER THE FREEZER DOOR.
TURN IT COUNTER CLOCKWISE ONE QUARTER TURN AND PULL IT OUT. THE DIAL THAT LOOKS LIKE PART OF THE TOE PLATE WILL SLIDE OFF THE END OF THE FILTER. YOU CAN FIND A NEW FILTER AT MOST HOME IMPROVEMENT CENTERS OR YOUR LOCAL WHIRLPOOL DEALER.
Ice Maker Works, Water Dispenser Doesn't
I have a whirlpool side by side. water and ice in front. ice working and water not. the hose is not frozen and it is not humming when you push the water dispenser. It would give us water and quit but now we have nothing.
Why is the heating indicator always on?
Not sure what "heating" indicator you are referring to, but if it is the humidity control, there is a switch on panel to turn it off. If you live in a warm, humid climate, you will want this switch left on.
Whirlpool side by side ice storage bin will not go back into place due to the auger
I had this exact same problem. After a difficult removal of the ice bucket (admittedly a lot of yanking against frozen ice cubes before I decided to chisel them out from above), I could no longer seat the ice bucket back onto the hexagonal auger drive shaft. When activating the ice dispenser, I could hear the motor turning, but the auger shaft itself would not rotate. The cause was that the auger shaft had moved upward through its stop grommet during all of the yanking to remove the ice bucket.
Take off the two hex screws holding the top plate around the auger shaft. The shaft is then easily removable and you can inspect it for slippage against the stop grommet. In the attached photo, you can see there is about 1/2 inch of clean auger shaft visible above the grommet, where the shaft has slid upward relative to the grommet. If this is the case, the fix is simple. Turn the shaft upside down and lightly tap the grommet around the edges with a small hammer until it moves back into place. Upon replacing the auger shaft, you can feel it seat back into the drive motor adapter.
How do i get to the start relay and the compressor on my side by side work pool refrigerator
usually located on the bottom left side after u remove the covering u will see it, its not that difficult to do. u can also check the compressor and relay with a multi meter, by checking counting the rating placing 1 prong to the start and 1 to the run winding prong ( for example both may give a combined total 24 ohms) on the start and run windings, then check them separately by attaching 1 prong to the start and 1 to the common or center prong, count the rating, do the same for the run winding and the common count the rating, then add them up, they should equal the previous total of both run and start windings originally 24 ohms in our example though urs may be different? there is an allowance differential of give or take 5 percent as long as the count is close, if not u have a bad compressor, if u continually hear it want to start but fails, u then have bad relay
Where is the water filter in my Refrigerator?
Look for a round part in the grille that covers the refrigerator under the doors If it's there that is the filter. Give it a 90 degree twist (after you shut off the water supply) and pull out. It may be hard to pull since there are 2 o ring gaskets that haven't moved in a while.
Not finding what you are looking for?