Whirlpool 25.6 cu. ft. Side-by-Side Refrigerator with In-Door-Ice Dispensing System - Page 3 - Answered Questions & Fixed issues

• twist the filter unit counterclockwise and it should pop up.

The socket that holds the bulb may have a burnt wire or the door switch that operates the light may be bad.

Sometimes the drain can clog with ice. If this is it - simple fix. Empty the freezer and find the drain. Put hot water in the drain with a turkey baster or try using a hair dryer to thaw the ice and let the water drain. A small amount of water drainage through this drain is normal. The water sits in a tray underneath and evaporates helped by heat from the compressor. If the drain plugs, the water will build up in the bottom of the freezer and become an ice block.

My refrigerator did this when the fridge temperature control door got stuck open and froze everything in the refrigerator. I tracked down the problem to a connection in my water supply filter. I just removed the filter and spliced the line. I doubt the same thing happened to you but you can probably find the leak by tracing the water supply to the ice maker/water dispenser.

Check your owners manual troubleshooting. See if you find an answer. Please be more specific. Sounds like it's "stuck" in defrost mode, since it uses electrical heating elements to make the freezer coils melt ice off, but only lasts long enough to remove the collected ice. I would guess the unit runs constantly, or cannot maintain temperature. If the defrost cycle is not working there is a timer not working, or relay, or somehow a very rare short in the defrost system.

Stand it back up. It won't work when it's out of position.

Hi!!!Hi!!! change your ice maker control module on your icemaker its letting to much water it show here its the one with with the white round wheel..change it and all should be fine..googd luck..

cant be possible it only seems like that, the fridge gets its cool air from freezer. check the freezer door seals, the fan and the more than likely defrost timer and cold control dial? might want to check the thermistors as well

Replace water supply line with the plastic tubing ice maker line. It fixed mine that had a metal braided line on it that made the water taste kie rubber and dirt,, after that I tried a vinyl braided line.and it made the water taste like garden hose water.. The plastic tubing was the cure. Reply and tell me what you have.

Drain valve plugged

There are only two "clips" equidistantly spaced along the length and near the top of the vent grill. Important: Open both doors on side by side as the top of the vent grill has a lip that extends from the top to under the two doors.. Pick a side and lightly pull straight out, repeating procedure for opposite side. Remember to open both doors when re-attaching.

It is normally plastic and clipped onto bottom metal plate of frame. But in certain models it is screwed in to unit at two corners. Put your model number at www.whirlpoolparts.ca to see the diagram.

Hi,

Here is a tip that I wrote about how to clean those coils..

RefrigeratorCondenser Coil Cleaning Refrigerator Repair

heatman101

These motors with the plastic fan are apparently failing so often that when I went to the parts store, the owner told me on guy bought 4 replacement motors for his condo complex. Buy the old version of the motor with a metal fan blade. You have to clip off the white connector on the wiring harness and then wire to the new motor using wire nuts (easy). It's a lot cheaper too - $49 for the motor and blade vs alost $100 for the crappy plastic one. Running llike a champ right now!

Same problem here. That can be corrected with a kit that Whirlpool sales and is a known defect that was covered while I was still under warranty. Stand your ground and demand a repair at no cost to you! Let me know if you have problems.

The water could have frozen in the door or in the reservoir behind the crispers. The filter could be completely blocked.

the condeser coils are not defrosting, there is a electronic control unit on the top side of the fridge side, go to repair clinic. com, it gives you step by step instructions. real easy fix, good luck

It may be that you fridge has ran out of gas or the fan which circulates the cold air has failed. Check to see if you can hear the fan working

You need to remove the handle befor eyou can tighten the mounting bolt behind it. T remove the handle just grab it and yank UP quick and hard. The handle will unclip and release, then you can tighten the bolt down and re-install the handle.How strong do you have to be?!!! Trying that and it won\'t unclip. Not sure how hard to try--or will you break something?!!You have to pull up pretty darn hard with a jerk. That is how both handles are removed on these conquest refrigerators

most indoor dispensers are just a pathway for the ice to slide down with a flapper the dispensing mechanism is inside the freezer itself. If for some reason you need to access the inside of the door it usually means removing the door seal to do so.