Top 20 Whirlpool ET0WSRXML Top Freezer Refrigerator Questions & Answers

Hi,

Check out these tips...they can help you figure out what is going wrong with your refrigerator and why it is not cooling

Refrigerator not Cooling or Fridge not Cooling

How to Defrost Refrigerator Defrost Timer Problem

Water Running in refrigerator from Freezer

Refrigerator or Freezer not Cooling or Getting Cold

heatman101

,,,,,,,,,,,,,,

blow it out with air

Hi, Is there a frost buid up or is the evaporator fan motor running? Let me know andI can help you further.

Vic

Hi, if the only way you could stop the water was to turn it off at the water source, you need to change the water inlet valve. Make sure you check the water fill line for any leaks before you change the valve.
If I canassist you in getting the vavle, please let me know.

Thanks
Vic

Check to see if the run-off tube at the back is plugged.

I dont know how old the fridge is - but if it a couple years old check at the back or the fridge - there should be a tube running down the back of the fridge down into the bottom tray. This tube funnels water from the freezer (condensation, or water from the defrost) down onto the tray holding the compressor where it evaporates with help from the heat off the compressor. Sometimes this tube can get plugged up with some scum or mineral deposits, causing the built up water to drain from inside the fridge.

The tube shouldn't be too hard to remove and clean out with some hot water and pipe cleaners. Had the same issue on on a GE fridge last year.
Hope this helps!

just put some washers (plastic washers are best) on the hinge pin to raise the door

Water from the melted evaporator frost is normally drained down to a pan mounted on the compressor . The heat from the compressor is normally enough to vaporize this water. Sometimes the evaporation may be reduced due to- high humidity (in the kitchen). Try keeping the exhaust fan on for a while. Also check if the drain line is blocked or shifted out of the drain pan.

You need a tech to check the problem, it seems to be some kind of electrical short or, if the fridge has an electronic control module, it may be the source of the proble.

Could be dead bugs in the drain line and other sludge built up in there...have your guy flush the drain!!

This model uses the cold air from the freezer, defrost complet unit for 24hrs, turn back on and it should work ok. Regards Advisor

Delete To replace the LED light in your Whirlpool WRSSDHW08 freezer, follow these steps:

1. Unplug the refrigerator to ensure safety.
2. Remove all the items from the freezer to give yourself more room to work.
3. Locate the light cover inside the freezer. The LED light should be underneath this cover.
4. Carefully pry the light cover off using a flat-head screwdriver or your fingers. Be gentle to avoid damaging the cover.
5. Once the light cover is removed, you should see the LED light module. It may be held in place by clips or plugs.
6. Disconnect the power supply to the LED light. This may involve twisting or pulling the plug from its socket.
7. Remove the old LED light module from the freezer.
8. Purchase a replacement LED light module from the Whirlpool website or an appliance parts store. Make sure to get the correct part number for your specific refrigerator model.
9. Install the new LED light module by connecting it to the power supply and placing it back into its slot in the freezer.
10. Replace the light cover by snapping it back into place.
11. Plug the refrigerator back in and test the new LED light.

If you have any trouble replacing the LED light or if you are unsure about any steps, consult the user manual for your Whirlpool refrigerator or contact a professional appliance repair technician for assistance.

The Whirlpool WRB322DMBM01 refrigerator model typically does not have a dedicated water filter for the ice maker. Instead, it relies on an external water filtration system or an in-line water filter that may be installed in the water supply line connected to the refrigerator. Here's how you can check for and change the water filter for your ice maker: 1. **Locate the Water Supply Line**: Trace the water supply line that connects to the back of your refrigerator. The water supply line is usually a flexible plastic or metal tube that runs from the water source (such as a water pipe or faucet) to the refrigerator. 2. **Check for an In-Line Water Filter**: Look along the length of the water supply line for any inline water filters. These filters may be attached to the water line using compression fittings or push-to-connect fittings. They are typically cylindrical or rectangular in shape. 3. **Inspect the Filter**: If you find an in-line water filter, inspect it to determine its type and condition. Some filters have a label indicating the brand and model number, while others may have a date or indicator showing when it was last replaced. 4. **Replace the Filter (if Necessary)**: If the water filter is due for replacement or is visibly dirty or clogged, follow the manufacturer's instructions for replacing it. This typically involves turning off the water supply, disconnecting the filter from the water line, and installing a new filter in its place. 5. **Flush the System**: After installing the new filter, flush the water system to remove any air or debris. Run water through the dispenser or activate the ice maker to purge the system of any trapped air or loose particles. 6. **Monitor Performance**: Monitor the performance of your ice maker and water dispenser to ensure that the new filter is functioning correctly. It may take a few cycles for the water system to fully adjust to the new filter. If you cannot find an in-line water filter connected to your refrigerator's water supply line, it's possible that your refrigerator does not have a built-in water filtration system for the ice maker. In this case, you may need to consider installing an external water filtration system to improve the quality of your ice and water.

Check the control panel or display on the refrigerator for any error codes or indicators that might suggest a malfunction. Reset the control panel by unplugging the refrigerator for a few minutes and then plugging it back in.

Question turned around for clarity. Whirlpool sell spares including wire baskets https://www.whirlpoolparts.com/Shop-For-Parts/a3b5i554-x676435736861/Gd5sha-Whirlpool-Freezer-Basket-Parts Or places like this https://www.appliancepartspros.com/search.aspx?model=gd5sha ..

https://www.appliancepartspros.com/repair-help/whirlpool-refrigerator-wrf535smbm00-repair/wrf535smbm00-ice-maker-not-making-ice.html Whirlpool Refrigerator WRF535SMBM00 Ice maker not making ice Causes of a bad icemaker cycling thermostat can include electrical malfunctions, temperature sensor issues, or wear and tear. Symptoms of a bad icemaker cycling thermostat may include: Inconsistent ice production. The icemaker not cycling properly.

HOW-TO: Whirlpool Refrigerator WRF535SMBM00 Ice maker ...

There is no water filter.

Where is the filter for water for ice maker located on

JustAnswer https://www.justanswer.com > Appliance Repair Jul 23, 2018 - This particular model does not have a filter built into it so that is why you can't find one. If you wanted to add a filter, you can get an in- ...

If it has a defrost timer, some are adjustable. If not just replace it. https://www.google.com/search?q=Whirlpool+freezer+defrosting+too+often ..

Click on Part 20, Bi-Metal Defrost. I have never seen one like this before! https://www.partselect.ca/Models/WRT549SZDM01/Sections/Liner-Parts/?ModelID=7185057&ModelNum=WRT549SZDM01&mfgModelNum=&ManufactureID=3&Selected=28E07ECB18AF9AC514E92A1E4DCDBD928C532352&Position=4&mfg=Whirlpool&Type=Washer&Mark=4 ..

See page 11 troubleshooting of manual. This problem is discussed there. Whirlpool GS5VHAXWY - 25.6 cu. Ft. Refrigerator Use And Care Manual (Page 11 of 37) ' ManualsLib

Question edited for clarity, spelling of maker, toss in a load of CAPS. Question moved from Cars and Trucks. Yes they do. https://www.google.com/search?q=whirlpool+et1mtkxkq20 ..

Question edited for clarity Zeros (0) and ohs (o) aren't interchangeable in serial numbers :>D If icemakers are going wrong it is best just to replace the complete icemaker unit. They work in a very hostile environment or cold, wet, electricity and limescale and bio-slime. Some commercial icemakers I have witnessed in catering facilities would have you never taking ice in a bar or restaurant again! https://www.google.com/search?q=Whirlpool+MFI26665XEW3+parts ..