20 Most Recent Speed Queen AWS52NW Top Load Washer - Page 5 Questions & Answers

MAKE SURE MACHINE IS TURNED OFF. TAKE THE WASTE PIPE OFF OF THE SINK DRAIN PIPE AND BLOW UP IT AND LISTEN FOR BUBBLING IN THE MACHINE. IF YOU DONT HEAR ANY AND IT IS HARD TO BLOW ITS JUST A BLOCKAGE. KEEP TRYING THE BLOCKAGE USUALLY CLEARS. IF IT DOES REPLACE PIPE AND RUN MACHINE ON SPIN CYCLE THEN REPEAT.

likely the lid switch has failed.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

It has a volume capacity of 3.3 cu/ ft .

Sounds like a timer.

AMANA WASHER If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

The problem is the water inlet valve has failed. There is a video on checking this at www.appliancehelponline.com/servicemanual.html it's a different model but the testing procedure will be the same.

Easy,It just slips over the fluid drive after disconnecting the link to the spin solenoid, then on to the pump pulley.
Adjustment is made by the motor mount.adjustment bolt.
Good luck.

You probably have a worn seal that is allowing transmission oil into the tub. Contact an appliance service company.

It is a pleasure for me to offer some assistance to users all over the world. The problem you are describing to me is a very common for any amana, speed queen washers. The tub seal leaks and washes the lubricant from the upper bearing making the roaring noise in spin. The bearing needs replacement now, also the tub seal comes as a kit to rebuild all the sealing surfaces. It also does require a complete dissasembly to install the new kit plus the bearing. I would charge 3 hours labor @ 75/hr and the parts would be around $100 for the hub-n-seal kit and the bearing. However you may want to consider a new machine with a better warranty (extended warranties are a MUST these days......BUY ONE with any new appliance. Hope this helps let me know if you have any questions. Unfortunatly these Speed queen design washer have a myriad of design problems and this is only one of them.

I could not find an appropriate size automotive belt and then purchased the correct belt from the agents

Your washer is 3.3 cubic feet capacity...

Normal 0 false false false MicrosoftInternetExplorer4 Try this.. Turn OFF the power. and remove the front vertical panel by inserting a drywall knife in a the top right about 4" in from edge at the joint 1" down from the top, push the clip back to release that corner, get another knife and do the same to the left top corner, the pull the top of the front panel and swing towards you, then lift off and remove.

I seems the mixing valve is not allowing hot and cold to be mixed.

I've had the same experience with my Speed Queen washer. Approached the accredited Speed Queen agents for assistance, when tech support was deployed to diagnose the problem.
In the end, I was told that the "timer" went bust. So the wash cycle seems to work 100%, but when it comes to rinse and spin the contacts on the timer don't make contact, and the motor waits in anticipation for it's next command, and that the high pitch noise heard.

Worn main seal...major job.
Do not use machine.....240volts + Water = Morgue

in orde to open it
you will need specalty hub tools to get it out

sillicone If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61