Whirlpool Cabrio WTW6600SBT Top Load Washer - Answered Questions & Fixed issues

Mine does exactly all of those things you mentioned. I can't afford a new washer or even a new washer if they gave me a credit I also get white spots on my dark clothes and I am using very little detergent.

how old is machine now? they came out with a new wash plate , designed differently to be less aggressive on clothing. part num W10141017

how do i reset a whirlpool cabrio wtw5500xw2

theer have been no reported problem with using the DREFT baby soap in the HE made machine,

Spring: Thank you for your review. We would like to inquire further about your review with you. Please respond back to this email address, [email protected], with your name, phone number, street address, zip code, model & serial number, and date of purchase on the appliance. We look forward to your reply. Thank you, Whirlpool® Social Media Relations

Sounds like you have a transmission leak.The bearing wouldn't throw that much grease.

I would call the Whirlpool machine repair person for a quote as only an experienced engineer will know what the problem is eric

it sounds like the water pump is not emptying properly, blow down the water outlet pipe to see if is clear if not go to the water pump and clean it out there is probably a button , paper clip or other debris preventing it from doing its job eric

Apparently it's a common fault (among others) with this brand/model of washer; as Whirlpool has dedicated a page to it. How to clean the interior of your washer to remove odors

Sounds like a blockage between drum and pump or outlet water hose to drain,or the pump needs replaced

You may have something like screws or nail or something that was in some ones pocket or just fell into the tub . You may have to take the agitator out to get it out unless you can get something under it to get it out. This is pretty common I've seen nails get in a hole & wear a hole in the drum , then you have a leaking drum. Not sure but sounds like this may be your problem. Hope this helps good luck

Sounds like a control board problem

Most likely actuator is not engaging into spin mode or yellow pulley has come loose and not engaging or slipping.

Model # please?

My dryer did the same thing, it was so distrubing noise in the middle of drying cycles, so I turned off the sound switch it went away, now it doesn’t peep any more.

In many cases the spinning motor is problem.

Bite the bullet and tell him, its a lot better to get him or somebody who knows how to do the work than to make it worse or destroy it all together figuring it out. The drum comes out pretty easily, but definitely not a process I would feel comfortable walking someone through

That sounds like the gearbox has gone bad, I've replaced several that were doing the same thing and were still under warranty

If all obstructions are removed, and still doesn't drain, replace pump.

So when you say it's not pumping all water out, is there still water standing in tub or no water standing and clothes are just sopping wet? Is machine spinning? If not spinning, could be actuator that shifts transmission from agitate to spin.