20 Most Recent Canon imageRUNNER 2200 - Page 5 Questions & Answers

replace taflon film u r machine will be ok

Where do i find waste toner container in canon iR3225

Read the Manual (comes with Tool). If you don't have the Tool download it from the Canon site. Go to the copier and press the System/Options button next to Copy/Mailbox/Fax. Press Online. Then try scanning. Go back to copier and press Offline so can photocopy again.

Heater temperature error (abnormal drop; low-temperature detection)

The main thermistor reading is lower than 140°C when paper is moved.
Main cause:
The fixing film unit is faulty (i.e., the main thermistor (TH1) has poor contact
or has an open circuit; or, the fixing heater is faulty). The main power
supply PCB is faulty. The DC controller PCB is faulty.
Caution:
To clear the error, execute the following in service mode:
COPIER>FUNCTION>CLEAR>ERR.
Action:
1. State
Turn on the power switch, and clear E002/E003. Thereafter, turn off and
then on the power switch. Does the fixing heater operate?
NO: See "The fixing heater fails to operate."
2. Wiring
Is the wiring from the DC controller PCB to the fixing film unit normal?
NO: Correct the wiring.
3. Fixing film unit, DC controller PCB
Try replacing the fixing film unit. Is the problem corrected?
YES: End.
NO: Replace the DC controller PCB.

remove the image processor pcb and the ram. wash it with petrol and then dry it. insert it in the copier. if the problem comes again then replace the pcb's

If you know the password, then under user mode, i think system sett., must be option for department id management where you can change passwords.

If you dont have pass, you can do clear all under service mode ( * 2 8 * ) if canon changed service mode, like on some series, you can try MENU and #.

Hope that helped

Film not rotating replace film

Error Code
E602-0001, 0002
Indicates the presence of an error in write/read operation.

Clean the optics parts,mirror ,lens,clean the image unit parts,drum cleaning blade and the charge corona roller and the transfer unit parts.

fusing film

The error code deals with the scanner unit / scanning lamp. Have you just cleaned the optic's???? Was the problem there before you started to work on it? Dos the scanner lamp turn ON? I the lamp dos not come on, you will need to replace the lamp and the lamp regulator PCB at the same time as a set. Very,very important... They need to be changed as a set. If you have a working parts machine, I would use the parts from the parts copier. Good Luck

All I can offer is From Canon:

Problem :
The machine displays an error code of E220. The code only displays when copies are made off the glass. Originals copied using the Document Feeder do not cause the code to occur.

Solution :

Unplug the copier and remove the Copyboard glass. Move the scanner manually and check to see if the Scanner Home Position Sensor Flag is coming into contact with the Inverter Pcb, or any of the wiring. Contact with the flag may be causing a short during Scanner movement when copying from the glass.

Problem :

Error Code E220-0001 occurs after replacing the Lamp, Inverter PCB and the Reader Controller.

Solution :

Check and verify the 24V supply to the Reader Controller from the Main Power Supply (Switching Regulator) is present. It is possible that one of the loads on the DC-Controller can take down the 24 volts. Remove the 24volt loads off the DC-Controller and connect the connectors one by one to locate the short or defective load.