20 Most Recent
Canon imageRUNNER 2200 - Page 3 Questions & Answers
Cannon image runner 2200 error code E000002-0000,
E002/E000/E003/E261/E733 Error code: Due to AC line noise Error Code
Symptom
E002/E000/E003/E261/E733: due to AC line noise.
Description
E002/E000/E003/E261/E733 occur due to AC line noise.
If the above error codes are frequently recorded in the error log, they might concern AC line noise.
Cause
When the machine tries to detect a Zero-cross signal of AC line, it will fail if a noise occurred around the zero-cross point. Since the fixing temperature is controlled based on the zero-cross signal, there is a possibility that the fixing temperature could not rise properly if a noise occurs several times.
Field Remedy
Replace the Switching Regulator PCB ***'y with a new one.
120V: FH3-2613
220V/240V: FH3-2614
The circuit has been modified to resist a noise.
REMEDY
Caution
Press (* then 2 and 8 together then *)you are in service mode monitor:To clear the error, execute the following in service mode: COPIER>FUNCTION>CLEAR>ERR.
GOOD LUCK MATE ......KINDLY RATE ME !!!! THANKS.
3/18/2014 9:04:31 AM •
Canon...
•
Answered
on Mar 18, 2014
Error code E000740-0003
hi the error code means tah lan card cannot be read and faulty check the harnes betwen it and the PCB if its ok change the card thanks.
2/19/2014 5:17:23 PM •
Canon...
•
Answered
on Feb 19, 2014
Clear E000002-0000 on canon ir 2200
Press the usermode star and release and then no 2 and 8 togheter and relealese,press the usermode star again.The machine will go in to service mode.Select copier and then on the next screen select funcktion and then clear.press the error and select ok.Switch the machine off for a minute and on again.The machine should be ok.After the clear has been done and the error is still showing then the fixing unit is faulty.
1/30/2014 12:52:42 PM •
Canon...
•
Answered
on Jan 30, 2014
For ir 2318 error code **E000003-0000
this is a fixing related error ...
if u have replaced fixing film make sure not to remove the thin heater
2- if u have removed it for cleaning purpose u may have fix it in wrong direction A------------------B B---------------------A
or check the main connector
1/1/2014 6:36:18 AM •
Canon...
•
Answered
on Jan 01, 2014
**E000003-0000
This is a main thermistor reading is lower than 140 celcius, main cause the fixing film unit is faulty, you can try clearing the code first to see if it resets, by going in to service mode on he panel display select *28* the 28 together, you will have a new sceen then select COPIER> FUNCTION>CLEAR>ERROR, then turn off then on.
fist primary cause would be the fixing film unit.
12/1/2013 10:01:34 PM •
Canon...
•
Answered
on Dec 01, 2013
Not finding what you are looking for?