Top 20
Crosman (4032) Questions & Answers
I have a crosman model
I have the same problem and have dealt with guns for 40 years !I am glad to see that the other folks have some realistic and innovative ideas of how to remedy this problem.I went to Lowe\'s on a "tip" and found some very small \'O\' Rings for $ 0.87 for two and I am experimenting with them. The first try I couldn\'t crank the screw down far enough to even puncture the CO2 Cartidge. Using a larger screwdriver I finally managed to puncture the cartidge, unfortunately it still leaked but waas a much smaller leak. Still experimenting. I am going on-line to locate the Model 380 Schematic diagram which is where I ran int this site. Good luck all !
When i instert the co2
Take a short strip of teflon tape and put it over the end of the co2 cartridge, make sure its in straight and tighten, works good.....:)
Crosman c11 - co2 cartridge
This typically occurs when the o-ring seal near the needle to puncture the container is missin or damaged. Use a flash light and see if you can inspect the canister valve location to cehck the o-ring.
You may need to take the unit apart to check the parts. If you do not feel comfortable doing so then you need to send it for service or have someone that can work on it do so.
I can pump the gun
there is a bleed off valve that prevents too much pressure. and there are rubber o-rings that can fail
What is the diameter of
The diameter of the bore/caliber is .177
or
.00177 of an inch
or
.0044598 mm
The outside diameter... the barrel is housed in a muzzle. You would need to physically measure or contact Crosman for those details
Best of Luck!
Not finding what you are looking for?