Amana PTH123B25AJ Heat Pump Air Conditioner - Page 4 - Answered Questions & Fixed issues
I have a ptac unit
Hello,
The solution can be view and solve from two process.
1). From the fan connected to the evaporator and ,
2). From the compressor connected to other power component.
Please this answer this question on your own?
(A) Does the fan run before it finally stop running
(B) Doe it cool the room before it finally stop working if the air condition perform the above function before it finally stop,
then the below solution will lead you on hoe to go about it ,but both work then it need to be refill with gas
What you are to do to solve the problem is to carefully uncrew the air condition the trace the wiring program to the fan first of all the check if the is an brig or loss wire from the fan if there is fix up back to the fan but if there is very wires look to be fine then,
You will have to test the the compressor if there is a leakage from the gas with gas reader or detergent solution in water apply it with a form of clean rag round the condenser to detect were the leakage is from.
Hope this solution help?
Thank you and thanks for using fixya.
10/20/2010 8:17:25 PM •
Amana...
•
Answered
on Oct 20, 2010
•
55 views
The light on the board
If the indicator light wont turn on but the air conditioner still cools, the control panel maybe unplugged from the circuit board or the control for the led light on the circuit board may have gotten defective. If this is the case, you need to call service. If you need further help, reach me via phone at
https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
10/20/2010 6:59:02 PM •
Amana...
•
Answered
on Oct 20, 2010
•
148 views
Heat pump wont come on and wont heat
more info is needed are you getting power to it does it try to do anything is it new how old is it has it ever worked what happened when it quit any info that you can give no matter how small helps we are not their and their is about 10000 possible answers rite now that need to be narrowed down
9/18/2010 5:32:21 PM •
Amana...
•
Answered
on Sep 18, 2010
•
131 views
NO COOLING
Hi,
Here is a tip about troubleshooting your air conditioner...
There are many things that can cause your air conditioner not to cool…
Air Conditioner Trouble - Review the Possibilities
heatman101
8/31/2010 3:07:26 AM •
Amana...
•
Answered
on Aug 31, 2010
•
198 views
Not getting cold air
1 Check that the unit still has elec. supply.
2 check overload trips to compressor / fan
3 check gas charge (is it leaking and locked out on low gas?)
4 possible pressure switch fault.
7/22/2010 2:20:17 PM •
Amana...
•
Answered
on Jul 22, 2010
•
163 views
Model PTC093B35AMBP .AC unit will not start., fan
The very first thing to check is the capacitor. If it looks swollen or leaky it probably has failed.
When both fan and compressor won't work their is an excellent chance this is the problem. If that is ok the control would be next suspect. Since BOTH compressor and fan won't run you either have a capacitor or control switch malfunction. I am leaning towards the capacitor route. Let me know
If you need further help, reach me via phone at
https://www.6ya.com/expert/dan_73bbd84fe1d95b61
7/6/2010 10:36:29 PM •
Amana...
•
Answered
on Jul 06, 2010
•
448 views
What is the thermistor ?
It is a thermocouple type thermostat.
Thermal resistor. It sends it's signal by varying the resistance it has.
7/1/2010 4:11:27 PM •
Amana...
•
Answered
on Jul 01, 2010
•
219 views
House wont cool ..tried to reset breaker in fuse
Does this unit have 2 breakers to it? The model you put down is a PTAC and generally just plugs in to the wall so it would have only 1 breaker. If I recall correctly it's got a 5 year warranty on parts so it may be worth it to check with your local HVAC tech and have them do a diagnostic for you. A good place to start would be Amana who can tell you the authorized service company in your area. They'll get the part for free and should roll the diag fee into the repair cost so you'll only pay for labor (if it even needs a part). Their sales and service number is:
1-800-647-2982. Here's a link to your warranty info:
http://www.amana-ptac.com/Home/Warranty/tabid/449/Default.aspx
5/27/2010 2:36:31 PM •
Amana...
•
Answered
on May 27, 2010
•
384 views
Blowing of cold air every 5 minutes, and it says FP on the screen
FP is the code for frost or freeze protection. The unit will automatically do this periodically to prevent any damage caused by low temperatures although it should not be running as frequently as every five minutes. If the outside temperature is not low then it could either be a problem with the exterior thermistor (not the one you see from inside your room) or the control board could be on its way out.
5/21/2010 10:49:12 AM •
Amana...
•
Answered
on May 21, 2010
•
4,170 views
I have Amana heat pump, I dont know why it does
sounds like your resetting the compressor its going off on high head pressure. check and make sure the condensor coils are clean. and that the fan is running properly.
5/10/2010 4:44:55 PM •
Amana...
•
Answered
on May 10, 2010
•
218 views
Error code F1
Indoor ambient thernistor (black) may need replaced.
3/19/2013 8:53:04 PM •
Amana...
•
Answered
on Mar 19, 2013
•
451 views
CODE
Un-configured service board. Board needs to be set to either cooler with electric heat or heat pump. Enter config menu and set C3 to either "c" for coolers or "h" for heat pump. For newer boards config menu is accessed by holding down the up and down arrows and quickly pressing off twice.
5/7/2010 11:05:45 AM •
Amana...
•
Answered
on May 07, 2010
•
677 views
Is it normal operation for these units to EVER
Yes. Heat pumps have to go into defrost just like a freezer when the temp gets too cold outside. The heat pump will temper the indoor air electric heat.
4/19/2010 7:29:48 PM •
Amana...
•
Answered
on Apr 19, 2010
•
413 views
Not finding what you are looking for?