20 Most Recent Sharp AR-5320 Black and White Copier - Page 5 Questions & Answers

Check if the toner is properly seated.

you must use ar-202 developer.205sd used for 5516 or 5520

Check the paper feeder roller, it might be dirty , or may need to be replaced if it is too old.

press and hold the lighter density key until all red lights blinks and then press and hold zoom button to display toner level

CH fix close cover CH blink toner issue

if you do not add the addditional memory on the main board it will not function.

Replace panel first

go to sharp australia

simulation 42 01.

Install in compatibility mode for win 764 bit

Wrong driver :install again

Replace MCU:main board

Sorry i have not use that model before so i can't give any solution. Rich.

Not much to go on, but if something stops doing it used to do normal before, try to go back in time, to discover if you changed anything. Also check if the copier is still connected and it is not switched off. Actually, if you start a copy, it should work, or give a message on the display why it does not work. Restart the machine and try to copy again. watch if anything is on the display. If nothing lights up, start checking the power outlet and if the power cable is still connected to the machine. Then check if the power switch is working and so on.

Your exposure lamp reflector may have gotten bent this was a common problem to occur after PMs. Otherwise there is an issue with the lamp. Power cycle should clear it after you resolve the problem. I’m happy to help further over the phone at https://www.6ya.com/expert/ethan_e84416e0b13809d2

you should change the toner cartridge.