20 Most Recent Sharp AR-5320 Black and White Copier - Page 3 Questions & Answers

check the drum and the transfer/seperation assy directly below it Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

check the duplexer which is what is used by the copier to print on the other side of the copy Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

try this Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

thermistor open , check thermistor , might have to replace

check out a dealer ship Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Fuser code the hot part is bad. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

faulty toner.

Must likely your problem in fusing unit gear you have to disassemble it to identify the pad gear

normally it is from the development unit or ATC sensor from the toner

E7-10 Shading trouble (Black correction) The CCD black scan level is abnormal when shading. Improper connection of the CCD unit flat cable CCD unit abnormality MCU PWB abnormality. http://www.printcopy.info/?l=en&mod=free&chap=erc&brand=Sharp&model=AR5320 upon on extra research I've found that this problem was once solved by tightening any loose panels and screws... Thread Sharp ar5320 error code e7

U should apply it # int c int. Then14 start

see paper jam .i don`t know whitch lamp is on tell me about it

driver to instal printer ar-5516

HI Don't think printing a report is an option Cheers Andy

check your front & side covers; close them very well .make sure that the two switches of both covers are ok, & lastly if ch is still remaining after all this go & read the fuses at the powerboard & replace the blown fuse with the correct value. thanks

This looks like a dup but there should be buttons to handle this right up front.

Shutter speed is exposure ,read up and go from there