20 Most Recent Keurig B70 Coffee Maker - Page 2 Questions & Answers

I blew out the tip and the water intake with my nail gun air compressor. Tried the tip first without any results. After I tried the water intake, hot water started to drip from the tip. Worked fine afterwards. Like other people have stated, water will spray, so make sure you cover the inlet and outlet areas with a towel. Their is a second outlet that is a piece of rubber that drains into the back of the water storage area. It points down and is ment to drain back into the water holding tank. Hot water could spray onto you hand after using the compressed air so be careful.

#1. Use the paper clip trick on both top and bottom punchers. The holes are in the side of the punchers. (lots of video in youtube) #2. Descale it again with vinegar and leave it for 15-24 hrs before brew rinsing, (instead of 4 hours as mentioned on the manual) #3 some said, turning it upside down and giving it a shake, #4. visibly check the screen on the the water reservoir tank entrance clean if there's any visible clog. #5 Still having a problem, then, for the last resort, before deciding on replacing the diaphragm pump, open the bottom metal part (5 screws), inspect for any visible drip of water (accumulation of white hard water stains, or discoloration on the metal) visualize where it's coming from. Mine is on 2 areas--from the diaphragm pump (where there's 3 black screws) and where the connection of the main pump to the reservoir. This is good news, it means nothing wrong with the pumps. it's just been leaking a little bit of water on the connection (must be air tight, any leak will decrease the pressure). The common sense FIX: depress the metal clamp and pull the plastic tube out, clean the inside and the connection and re-attach it back making sure the little leak will stop. same with the other one then, then replace the other smaller tube with a new tie wrap and make sure it's air tight. Basically you just check all the hose connections make sure it's air tight..

Hi,

Yes, it may take more then one time...

Check out this tip about how to descale your Keurig coffee brewer

How to Descale your Keurig Coffee Brewer

heatman101

Hi,

Here is a tip that I wrote that will give you some things to try that will help you get your Keurig coffee brewer working again.

Keurig Coffee Brewer not making a full cup of Coffee

heatman101

;'';=-

there are a few things that can cause this; 1) You may need to clean the needle in the coffee exit where the coffee pod sits and gets pierced when the top is closed. You do this with a needle, be careful the point of the piercing nozzle is sharp and the needle point is as well. 2) There is also a needle in the cup holder under the pod that cuts the hole for the coffee stream, this needs to be cleaned with the needle. 3) The filter in the water tank may be plugged and needs to be cleaned. 4) The pump may be clogged with lime and scale. 5) The heater element may be scaled with lime. 6) Items #3 to 5), to fix this use DE-scalier, or vinegar solution, the pickling strength works better than household variety, but both are OK. 7) run the cycle for coffee, no pod, 3 times, this should clear the taste of the vinegar. Hope this is your solution.

https://www.youtube.com/watch?v=NDE0QP94KDQ

http://www.singleservecoffeeforums.com/dissassembly-repair-guide-keurig-b70-platinum-t8124.html

remove and clean or replace the filter in the water reservoir.

Have you tried descaling your Keurig? This should improve the volume of water coming out of the coffee maker.

Hi:

I had the same problem when mine was only 2 weeks old. I kept turning it off and restarting it to no avail. I know it sounds overly simplistic, but I eventually unplugged it and then plugged it back in. I presume this reset some balky circuit because it has worked fine ever since.

I hope this simple suggestion is helpful.

Regards,

Dave

Yes, They have started to sell them in England, with 220 v. The Keurig K140. http://keurig.co.uk

Do not send it to them. The guy that suggested this is totally wrong! They will not accept it. No one will accept anything back without a RMA. Check keurig.com to see if there is a recall. The only one I just saw was a recall on what I think is one of the new 2.o models. They will tell you how to proceed if they determine you yours is bad. I was told to send them my K-Cup holder as proof of purchase when they agreed mine was defective. I just checked Keurig.com. The only recall currently is for the K10 mini brewer.

Any place that heat and liquid can get trapped, mold can occur. This is why descaling is important for traditional coffee makers and even for tea pots. Basically, keep your stuff clean. Biofilm Slime Bacteria inside the inner tubes of the Keurig Coffee maker