Top 20 Kyocera CS-2550 Black and White Copier - Page 11 Questions & Answers

https://www.kyoceradocumentsolutions.com.au/support/technicalsupport

Dp unit steel rod clean

KYOCERA Technical Support. 800.255.6482 https://global.kyocera.com/inquiry

its the fuser unit has to do with warming on start up can be expensive to replace

Press 10871087 start 906 start execute start

Try to update the FW

run sim 163

You have a bad hard drive.

There are many reason for that. Make sure using proper paper quality. Which are not much moisturized. paper are not folded much and kept in good place. Clean the paper tray.

take off the cover and wipe down all edges of surface where it fits with an acohol wipe. Not enough mpoisture to screw it up but it should get pretty much everything

Use heavy weight paper

Check sensors and clean feeder with wet clothes

Mylar tabs are bent over in feed unit. Push a stiff thin piece of plastic (like a help wanted sign) the same way the paper feeds through.

Description BD steady-state problem ASIC detects a BD error A for 2 s after the polygon motor rotation has been stabilized. Causes Poor contact in the connector terminals. Defective laser scanner unit. Defective engine PWB. Remedy Poor contact in the connector terminals. Check the connection of connector YC8 on the engine PWB and laser scanner unit, and the continuity across the connector terminals. Repair or replace if necessary. Defective laser scanner unit. Replace the laser scanner unit. Defective engine PWB. Replace the engine PWB and check for correct operation.

The eject sensor (ES) does not turn off during paper feed from cassette 1

make sure your destination setting is USA

You can read the manual for the device and the command center in order to setup the Scan to SMB.

How old is the printer? You may need to look into getting the correct maintenance kit.

You have a bad FUSER unit.

The first thing you should do is a FW upgrade