20 Most Recent
D-Link DCS-5220 Network Camera - Page 6 Questions & Answers
We are having problems with
I attempted to use
D-link equipment TWICE in the past...
I went as far as wasting a net of
3 hours each time with their "TECHNICAL" support...
OVER & over... to the definition of insanity...
Had anything worked I would tell you ABOUT IT.
I would strongly recommend you
return them from
WHERE-EVER you purchased them...
NOW.
My next was a single unit
NETGEAR...
Cost less and I had cable connected my video server
WIRELESSLY... in a matter of minutes.
My OPINION: Avoid the pain.
Carnac the Magnificent
I want to extend the
Instead of removing the antenna from the router you can buy a cheap working second hand router in market (better buy a second hand belkin router, because belkin provides free lifetime phone support also free lifetime hardware support for certain routers whose model numbers starts with F5D or F6D....Dont buy any belkin routers with model number that starts with F7D)
Now configure the second router as an ACCESS POINT (you can call 18002235546 to get help to change to an access point)
run a long ethernet cable from dlink router to the second router (belkin)... you can place the belkin router anywhere where the cable can reach...
The belkin router will broadcast the signal and you will get better signal strength...
I can't access the internet with my new D- Link
Is it plugged into your internet modem with a LAN cable and is your modem working? Is your router configured correctly for you internet service? Try a new LAN cable between the modem and router. Hard reboot both devices (off 10 seconds the on).
Dsl-2740b router connections freezes
The final solution is a factory reset of your router. You can do a factory reset by logging into the router using you browser. Go to the settings and perform a factory reset
If you forgot the router password, you ill have to do a factory reset by locating a small hold on the back of the router and insert the tip of of paper clip for about 10 seconds while the power is on. The router will be reset to out of box status and then you can set-up form scratch.
Not finding what you are looking for?