GE Nautilus 24" Built-in Dishwasher - Answered Questions & Fixed issues

I'm pretty sure the "air hose" is the drain hose from the dishwasher and is supposed to empty in the garbage disposal. Garbage disposals are made for this optional hook up with a plug you have to knock out and remove from the inside of the disposal. If you run the dishwater with the hose not connected to disposal it has to be going somewhere!

Cleaning screens is part of regular use of the dishwasher and how to should be included in the user guide. If you don't have one look for it on the internet by searching for user manual for your model number which can be usually found on the side of the door or frame where the door closes. Good luck.

If the screw is left in there it will eventually get to the pump impeller and severely damage it Try to get it out

It sounds like it is a board issue. The board tells the washer what to do. What brand do you have?

The best thing to do here cost wise is to replace the unit.

A dishwasher will never drain all the way. It is designed to hold water as to not let the pump run dry and keeps the seals preserved.

the fill solonoid , located within inches of water hook up fitting has a bad connection on the coil or has failed.

I've experienced the same thing. Try very slowly rotating timer dial, click by click, until the water starts. Sometimes 3 or 4 clicks will start water. (You're advancing the clock.) Usually water starts in before the dial points to, "Short Wash." If this doesn't work, advance the dial to, "Off," unlock and open the door, reset, close, the soap dispenser, close and lock the door, and slowly advance the dial until the unit starts. I think this problem is a clock to pump issue and what I've described does a reset of the system. This happens to me once or twice per month. Poor engineering but still better than buying a new machine...at least 'till now.

i am taking it to the dump... throw it in the gutter and go get another...

Try SearsPartsDirect.com, RepairClinic.com, AppliancePartsPros.com, EasyApplianceParts.com, CraigsList, and eBay. If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Chances are the plastic catch broke or wore off. If that's the case, you have to replace the entire soap dispenser. If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Bi-Metl Thermal Fuse: This is a thermal safety device that installs in the console. When the temperature inside the dishwasher gets too high, the bi-metal fuse burns out and breaks the circuit that allows electricity to flow to and from the main electric control board.

I do not believe there are fuses inside the dishwasher. When the Use and Care Manual mentions a fuse (Fuse is blown, or the circuit breaker tripped), it is referring to the Fuse Panel/Circuit Breaker Panel. What problem are you experiencing?

Check owners manual, or google

not draining or low water pressure or both!

drain hose leaking from water pump discharge line

i won,t too buy a g.e. dish washer model.gsd3400g00ww where can i find this model and how much it cost.

Suggest: 1)check if the hose was mistakenly attached to the cold water line instead of the hot water 2)if you mean the water is not being heated for the "sanitizing cycle"....then the heater element may be burned out or have a bad connection....or you have not programmed/selected the "sanitize" cycle. 3)if your unit was working OK and this problem just started....then I expect the problem is 2) good luck

Use vinegar it will get rid of the smell

It's most likely the timer set the timer to when it is gonna fill to a normal wash hook up a volt meter when it is in its fill stage make sure it is putting out 120 volts