Top 20
Hoshizaki Commercial Freezer KM-500MAH Questions & Answers
Wherehis alarm reset button?
KM says this is an ice maker. Reset button is on the control board. Board is in compartment on the right side where the power switch is located. Remove 2 screws and remove cover by sliding forward. Watch for wires, do this carefully. On the board, up at the top, is a small, white button. With power on, push the button.
6/12/2014 10:37:06 AM •
Hoshizaki...
•
291 views • 0 helpful votes
Hoshizaki km-1900 ice sitll up no going down
if your are referring to a harvest cycle not clearing the plates, there may not be enough heat to clear the plates or the defrost cycle is too short. Usually the first thing to check. start there my friend.
6/5/2014 7:40:36 PM •
Hoshizaki...
•
177 views • 0 helpful votes
Ice machine keeps freezing on the ice trays
If you are referring to the ice not clearing the evaporator plates, usually the defrost cycle is too short. Check that by watching the machine and when it goes into the harvest mode, see if all the ice comes off. If not, lengthen the cycle.
5/15/2014 4:20:27 PM •
Hoshizaki...
•
153 views • 0 helpful votes
No power to curcuit board
Check your "Bin Stat" first as most all machine have power sent to the control board via this control. Start there.
4/10/2014 2:03:13 PM •
Hoshizaki...
•
130 views • 0 helpful votes
Freeze back up timer3beeps
signal means freeze cycle is longer than 60 minutes. Look for: stuck float, water valve leaking water into the sump, Hot Gas Valve leaking hot gas into the cold side of the refrigeration system. Start there.
3/6/2014 7:49:54 PM •
Hoshizaki...
•
212 views • 0 helpful votes
Ice machine 3 beeps
signal means freeze cycle is over 60 minutes. Look for: stuck float, water valve leaking water into sump, hot gas valve leaking hot gas into the cool side of the refrigeration system. start there.
12/4/2013 4:52:28 PM •
Hoshizaki...
•
166 views • 0 helpful votes
Not finding what you are looking for?