Top 20 Amana AGR5715QDS Gas Kitchen Range Questions & Answers

Have it checked out by a QUALIFIED gas person!! Don't screw around with gas unless you want to wake up dead due to carbon monoxide poisoning or an explosion!!!! Gas is NOT a forgiving task-master.

Well it is working so that tells me your control has a problem.
Could be a bad sensor:


OR your silicone carbide ignitor could be weak:


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi,

Before you go working too hard to get you oven to go into the self clean mode(self destruct)....check out this tip...

Self Cleaning Oven Problem


heatman101

" Wish I had read this first. I never would have used the self cleaning option. Thanks for the info!!

Hello & Welcome to FixYa

This indicates a open/shorted oven temperature sensor and to solve this problem the sensor needs replacement. If you wan to be sure before replacing the sensor then you can test it with a voltmeter for around 1100ohms....if it reads more then this then it needs replacement however, if the reading is around or less then 1100ohms then it is the control board that needs replacement. Please get back to me if you have any other questions.

Kevin

Hi. This sounds like a weak igniter, the symptoms usually are: burner won't light, or takes longer than normal to ignite the burner, may or may not smell gas in the oven, does not maintain set temperature or burner does not come on fully. On gas ovens, a glo igniter is like a light bulb, the more you cook, the faster it wears out. Bottom line, needs to be replaced. Good luck.

the switch on the catch in the door is sticking . make sure there is no obstruction in the catch or the the wires on the switch are not shorting

What's probably being displayed is actually "Sab". This is an indication that the range is in "Sabbath Mode". This mode is set for those religions that honor the sabbath and disables the oven for about 72 hours. Unplugging the range will not clear this. It can sometimes be set accidentally following a power outage or inadvertently hitting the wrong button on the control panel.

If the model number you have this listed under is correct, you can cancel Sabbath Mode by pressing and holding the "CLOCK" button on the control panel for 5 seconds. If you refer to your Owner's Manual the instructions are listed under the Oven features section.

If you do not have a manual, you can go to managemyhome.com and download one for FREE.

If you have any questions, please let me know. If the model number is incorrect, please post back with the correct model number so that I may provide you with better assistance. I hope you find this information helpful.

The spark ignitor needs to be replaced. You can get it at your local appliance repair store or online at repairclinic,com. That is the way it tells you that it is bad by constantly clicking

U wud certainly taste it if that happend. Plastic not toxic if eaten..only if burned and emits fumes

bad ignitor

Contact manufacturers they may help. :-)

Try disconnecting the power to see if it will reset. If that does not fix it, it will probably need a main board, but more testing needs to be done to know for sure.

Assuming unit has cooled down, unplug for 5 minutes and then plug back in. If code still flashes and door doesn’t unlock, there’s a problem with latch associated parts, the control board, or wiring between the 2.

Not all stoves have thermal fuses.

Means oven is getting too hot. Replace oven sensor / probe.

It could be either. You will have to test voltage to burner. If it’s getting voltage to part of burner that’s not working, then burner is bad. If it’s not getting voltage, switch is bad.

Replace the switch for that burner.

Probably the control / clock that has a bad bake relay. Replace control.

https://www.searspartsdirect.com/part-number/0315154/0022/335.html http://applianceparts365.com/whirlpool-spark-module-part-0315154 https://www.deyparts.net/product/inv_0315154 https://www.deyparts.net/product/inv_0315154